Roland EP-7 User Manual

Making the Connections/Powering Up
Before
making
any
connections,
make
sure
you
have
the
power
on
your
instrument
turned
off.
AU
R Li
©
HEP
©
These connectors are used
when you wish to connect the
ep-7to another MIDI-equipped
device. For details please refer
to the separate "MIDI Guide-
book".
Once all connections. have been
properly made, press the Power
Switch to turn the unit on.
(The red indicator will light)
*POWER
With the pedal depressed,
notes will linger on after being
played. With sounds which
maintain a constant volume
level, such as Strings and Pipe
Organ, notes you play will con-
tinue sounding as long as the
pedal is depressed.
(Use the DP-2 pedal)
Listening to the Demo
it desired, you can have your
keyboard produce a more im-
pressive sound by connec ting
itwith a stereo system or ampli-
fier/speaker setup. To connect
the units, plug audio cables
into the keyboard's Output
jacks and plug the other ends
into the Input Jacks on your
sound system. If the equipment
you are going to use can only
receive a monaural signal, use
the keyboard's L (Mono) Output
jack.
Cord Hook
played.
(The supplied AC Adaptor )
Cp Press PIANO, VIBRAPHONE and STRINGS si-
multaneously.
PIANO E.PIANO VIBRAPHONE ORGAN TRİNGS
The demonstration song will start playing.
@To stop playback of the demo, press any Voice
button.
PIANO E.PIANO VIBRAPHONE ORGAN STRINGS
E ae | ef E
Im
@Adjust the volume.
VOLUME
Decreases Increases
The Cord Hook conveniently allows
you to secure the AC adaptor cord,
thus preven ting it from accidently
coming loose while the unit is being

Roland EP-7 Specifications

General

Type	Digital Piano
Power Supply	AC Adaptor
Keyboard	76 keys
Effects	Reverb, Chorus
MIDI	In, Out
Speakers	2 x 12 cm
Headphones	1/4" jack
Pedals	Damper Pedal (included)
Amplifier	2 x 20W