8
Turning on the Power
* Once everything is properly connected, be sure to follow the procedure
below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
1. Minimize the volume of this unit.
Also completely turn down the volume of any connected external devices.
2. Press the [
L
] switch.
The unit is turned on, and the display’s backlighting comes on.
3. Turn on the power to connected external devices.
4. Adjust the volume of the connected external devices.
5. Adjust the volume of this unit.
Turning o the Power
1.
Minimize the volume of this unit.
Also completely turn down the volume of any connected external devices.
2. Turn o the power of the connected external devices.
3. Press the [
L
] switch.
The unit is turned o.
* Before turning the unit on/o, always be sure to turn the volume down.
Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate
a malfunction.
* If you need to turn o the power completely, rst turn o the unit, then
unplug the power cord from the power outlet. Refer to “To completely
turn o power to the unit, pull out the plug from the outlet”
(p. 2).
Making the Power Automatically Turn o After a Time
(Auto O)
The power to this unit will be turned o automatically after a predetermined amount
of time has passed since it was last used for playing music, or its buttons or controls
were operated (Auto O function).
If you do not want the power to be turned o automatically, disengage the Auto
O function.
NOTE
5 Unsaved data is lost when the power turns o. Any data that you want
to keep must be saved in advance.
5 To restore power, turn the power on again.
Changing the Auto O Setting
1. Press the [MENU] button.
The MENU screen appears.
2. Touch <SYSTEM>.
The SYSTEM screen appears.
3. Touch <GENERAL>.
4. Select “Auto O” and change the setting.
Parameter Value Explanation
Auto O
O The power will not turn o automatically.
30 min
The power will automatically turn o if no
operation is performed for 30 minutes.
240 min
(default)
The power will automatically turn o if no
operation is performed for 240 minutes
(four hours).
5. If you want to store the auto-o setting, press the [WRITE]
button in the System screen.
Introduction
To Next Page
Loading...
Need help?
General
