16
Copy Mode—• This chooses the way in which pasted data interacts with
any data already at the Dst Measure location. You can set it to:
MIX—
• so pasted data is combined with any data already in the
destination location.
Replace—
• so pasted data takes the place of any data already in
the destination location.
Copy Times—
• This parameter allows you to paste your copied data
multiple times end-to-end. Set it to 1 if you’d like to paste only a single
copy, or to the desired number of copies you want.
You can use the Copy Times parameter to take a chunk of music you’d
like to use as the basis for a song—such as a rhythm or repeating lick—
and copy it multiple times to build out the song’s entire structure.
Status—• This parameter sets the kind of data to be copied. Select:
ALL—
• to copy all types of data.
Note—
• to copy only notes.
Poly Aftertouch, Control Change, Program Change, Channel
•
Aftertouch, Pitch Bend, System Exclusive, Tune Request—to copy
only the selected type of controller data.
Range Min, Range Max—
• This parameter does different things, depending
on the Status value. When Status is set to:
ALL, Channel Aftertouch
• , Pitch Bend, System Exclusive, Tune
Request—these parameters are inactive.
Note
• or Poly Aftertouch—they set the lowest key and highest key
whose notes are copied.
You can set Range Min and Max by dialing in the desired value, or
by selecting each parameter and touching the desired key on the
keyboard. Be sure to set Range Min to a lower key than Range Max.
Control Change—• they set the highest- and lowest-numbered,
respectively, Control Change messages to be copied.
Program Change—
• they they set the highest and lowest,
respectively, Program Change numbers to be copied.
Insert
You can add blank measures anywhere in a phrase to extend its length using
the Insert tool.
The Insert parameters are:
Measure—• This parameter selects the measure at which blank measures
are inserted. (New measures share the phrase’s time signature.)
For—
• This sets the number of measures to be inserted at the location set
with the Measure parameter.
Transpose
Use the Transpose tool to change the pitch of sequenced notes.
To Next Page
Loading...
Need help?
General
