11
HP-1 – Owner’s Manual
ENGLISH ENGLISH
ENGLISH ENGLISH ENGLISH ENGLISH
3.9 Adding Reverb
The HP-1 allows you to add reverberation to what you play on the keyboard. This effect gives the impression that you
are performing in a concert hall or similar space.
Switching the Reverb effect on and off
At power-on, the digital Reverb effect is switched off.
To use this effect, you need to switch it on:
1.
Press the [Reverb] button to switch the Reverb
effect on (or off).
The button’s indicator lights when the Reverb effect is
on.
2.
Repeat the above to switch the Reverb back off (or
on) again.
Setting the Reverb level
You can also set the volume of the Reverb effect to
accommodate the sound your are using. You may want
to select a higher Reverb level for the “Organ” sounds
(to simulate the reverberations of a church) than for
the piano sound, for example.
There are eight possible Reverb level settings. At
power-on, the HP-1 selects level “3”.
3.
Simultaneously press [Demo] and [Reverb] to
enter Function mode (both indicators flash).
4.
Press a key between the “A2” and the “E3” (see the
keyboard illustration above) to set the desired Reverb
level.
Softer Reverb
A
C
Louder Reverb
HP-1_GB Page 11 Friday, March 29, 2002 12:37 AM
To Next Page
Loading...
Need help?
General
