Roland HP 1700L - Program Change Transmission

& Using MIDI
o To select the mode
€ While holding [FUNCTION], press [MIDI MODE].
CHORUS CHORUS
FUNCTION MID! MODE MIDI! MODE
D
The [MIDI MODE] LED will blink, and mode II will be selected.
@ While holding [FUNCTION], press again.
CHORUS CHORUS
FUNCTION MIDI MODE MID! MODE
D
The LED will light, and mode III will be selected.
9 While holding [FUNCTION], press again.
CHORUS CHORUS
FUNCTION MIDI MODE MIDI MODE
D
The LED will go out, and mode I will be selected.
In this way each time you ress while holding
, you will cycle through modes 1, II, and II.
Each time the power is turned on, mode | will be selected.
Program changes
«Program change transmission»
Specify a Program Change number (1~128) by selecting the
Group (A/B), Bank (1—8), and Number (1—8). The selected
Group/Bank/Number corresponds to the transmitted Pro-
gram Change number as shown below.
Program Change Number Table
AWIN- jo NIIN eiw
a
97
F To transmit a Program Change
While holding [FUNCTION], press the keys corresponding
to the desired Group/Bank/Number.
r- PROGRAM CHANGE
HP-900L./900
j :
/ Z NUMBER 1-8 GROUP 4. E
( ) [BANK 1-8.
—————4
HP-1700L/1700
TUNCTION
NUMBER 1-8
L SANK : - 8
| —Ó——
o
* If MIDI transmission/reception mode M has been selected
(CPI), you can also simply press one of the sound select but-
tons to transmit the following Program Changes.
Sound select | Transmitted program
| buttons Change numbers
Piano 1 2
Piano 2 1
Harpsithord | 4
Vibraphone 6
E.Piano 7
23