Roland HP 1700L - Program Change Reception; Multi-timbral Mode

$ Using MIDI
«Program change reception?
When a Program enaps 1~8 is received, the corresponding
sound will automatically be selected.
Program Change
Sumber i Tone
| PIANO 2
2 PIANO 1
3 PIANO 1
4 HARPSICHORD |
5 PIANO 1
6 VIBRAPHONE
7 E. PIANO
8 E. PIANO
(J]Program Change numbers 9~128 will be ignored.
Multi-timbral mode
Multi-timbral instruments are able to function as several in-
dependent slave instruments contained in a single unit. The
HP-1700L/1700/900L/900 contains five instrumental sounds,
but can normally play only one sound at a time. However, if
the Multi-timbral mode is selected, you can use a different
MIDI channel for each sound, and use an external sequencer
etc. to play an ensemble of up to five sounds at once.
Multi-Ltimbral mode off
Sequencer one ot five sounds
Multi-timbral mode on
(J) Each time the power is turned on, the Multi-timbral mode
is turned off.
Sequencer
When the Multi-timbral mode is on, Omni will always be off,
and up to 24 notes can be played simultaneously; the same
number of notes as when the Multi-timbral mode is off.
24
F To select the Multi-timbral mode
While holding [FUNCTION], press [MULTI | to turn the Multi-
timbral mode on/off. When the LED is lit, the instru-
ment is in Multi-timbral mode.
REVERB
E 2p Tl
FUNCTION MULTI
D
While holding [FUNCTION],
MULTI ]LED will light to indicate
the Multi-timbral mode on.
default settings for each tone:
MIDI channel | Tone
1 ch PIANOI
lich PIANO2
12ch HARPSICHORD
13ch VIBRAPHONE
l4ch E.PIANO
«Messages received in Multi-timbral mode»
Incoming MIDI messages on channels other than 1, 11, 12,
13, and 14 will be ignored.
@ Program change messages
Program Change messages will be received independently
for channels 1, 11, 12, 13, and 14.
@ Pedal messages
The following Control Change messages will function in-
dependently for channels 1, 11, 12, 13, and 14.
Damper: control change number 64
Sostenuto: control change number 66
Soft: control change number 67
@ Chorus on/off
Chorus on/off messages (control change number 93) will
function independently for each sound.
@ Reverb on/off
Reverb on/off (a Roland exclusive message) will apply to all
sounds simultaneously.
@ Receive/transmit channel settings
In the Multi-timbral mode, the receive channels are perma-
nently fixed at 1, 11, 12, 13, and 14, and cannot be changed.
Nor it is possible to turn Omni On. Messages will be trans-
mitted on the specified transmit channel, But if you set the
transmit channel to one other than 1, 11, 12, 13, or 14, the
internal sound source will not produce any sound.