Roland HP 1700L - 1 Setup; Assembling the Piano Stand

How to assemble the piano stand
BE Check the parts
(Before you begin assembly, check that you have all the parts.
Side board (left):
Side board (right)
Pedal board"
Center board ©
Short screws (M4 x 27 mm) ^"
Long screws (M8 x 60 mm)
Knob bolts
Philips screwdriver
OONO 0000
Nn
E
E
procedure
Yr Extend the peda! cable out from the ED ELLE board.
(Note) Be sure that the side boards are oriented
correctly: the metal fittings are on the inside.
@ Use the long screws The metal fittings on the inside.
(M6 x 60 mm) to fasten
the side boards to the pedal cable
pedal board.
( use two screws tor)
each side.
(8) Fasten the pedal cable with the cable clamps (three
locations) on the teft side of the stand.
© Insert the two plugs from the pedal cable into the jacks on
the rear of the piano.
( Insert the brownplug into the DAMPER jack (red). Insert the)
blackplug into the SOFT jack (black).
@ Connect the power cable into the AC inlet on the back
panel of the piano.
The power cable is included with the piano.
@ Use the short screws (M4
x 27 mm) to attach the
center board to the side
boards.
[rs two screws for each
yx When you finish assembling the stand, rotate the adjusting bolt until it
touches the floor.
(Note) If the piano is placed on carpeting, rotate the adjustment bolt little more.
side.
(Note) When placing the piano in its location, be careful nol to pinch the power cable
underneath the piano.
(Note) When placing the piano on the stand, be careful not to pinch your fingers.
(Avoid holding the ends of the piano.)
(à Align the screws (one on each side) located
on the bottom of the piano with the slots _ Pa
in the metal fittings on the side
boards. Slide the piano so
the screws slide into the
slots.
(8) Rotate the
adjusting bolt
(à) Lift up the piano and until it touches
use the two connect- the floor.
ing screws to fasten
the piano to the
stand.
E: screw each
d
Rotate it to the
right to touch
the floor, and to!
the left to
retract.
side on the left an
right.