Roland HP-3 - Recording Along with the Rhythm

29
Chapter 4. Recording Your Performance
Recording Along with the Rhythm
You can record a performance that uses the Rhythm function.
fig.panel4-2
As described in steps 1 and 2 of “Recording a New Song” (p. 28), select the song
“USr” before you continue.
Selecting the tone and rhythm for recording
1
Select the tone that you want to play (p. 15).
2
Press the [ (Rhythm)/Beat] button, getting its indicator to blink.
The rhythm will sound. Set the rhythm and the tempo so that you can play
comfortably (p. 20).
3
Press the [ (Rec)] button.
The [ (Rec)] button’s indicator will light, the [ (Play)] button’s indicator will
blink, and you will be in recording-standby mode.
Start recording
4
Press the [ (Play)] button.
Recording begins after two measures of count sound.
Note that recording will also begin as soon as you play anything on the keyboard,
even if you do not press the [ (Play)] button. There is no count sound played
when you start in this manner.
Begin recording your performance along with the rhythm.
Stop recording
5
Press the [ (Play)] or [ (Rec)] button.
Recording will stop, and the indicators for the [ (Play)] and [ (Rec)] buttons
will go dark.
Play back the recorded performance
6
Press the [ (Play)] button.
You will hear the recorded performance.
Once again press the [ (Play)] button, and playback will stop.
If the rhythm does not sound when you play back the recorded performance
Is the [ (Rhythm)/Beat] button on (button’s indicator blinking)?
If you want to play back the performance using rhythm, turn on the
[ (Rhythm)/Beat] button.
1 3, 52
4, 6
HP-7
NOTE
If you record additional
material without erasing the
previously-recorded song, the
song tempo and beat will be
stored with the settings that
were first recorded.
NOTE
A performance you’ve
recorded using rhythm cannot
be played back with the
metronome.
HP-7/3_e.book 29 ページ ２００４年１月２６日 月曜日 午後５時１分