Roland HP 730 - Page 17

PLAYING THE HP 730/530e/330e
Using
Two
Different
Sounds
for
Right
And
Left
Hands
(Split
Function)
>)
The piano allows you to divide the keyboard into two sections, upper and lower, and to
play two different Tones. Dividing the keyboard is called “Split” and the key where the
keyboard is split is called “Split Point”.
1. Select two Tones by pressing the relevant Tone buttons.
2. Press the Split button, and the keyboard is split.
Play the keyboard and hear that two different sounds are played in the upper and lower
sections.
Ci C2 c3 C4 C5 C6 C7 cs
(ii
ry am
3. Press the Split button to cancel the Split Mode.
Split Tone List
Tone Upper Tone Lower Tone
Piano 1 Acoustic Bass Piano 1
Piano 2 Acoustic Bass Piano 2
Harpsichord Strings Harpsichord
Vibraphone Acoustic Bass Vibraphone
Electric Piano 1 Acoustic Bass Electric Piano 1
Electric Piano 2 Acoustic Bass Electric Piano 2
Pipe Organ Pipe Organ Harpsicord
Strings Strings Piano 1
* Chorus cannot be applied to the Tones with Acoustic Bass.
Changing the Split Point
1. Press a key on the keyboard while holding the Split button down.
Spit
=) u
C1 C2 C3 ca cs C7 cs
on LETT
down
fy The key you press will be Split Point
The Split Point can be set from AO - C6.
The Split Point you set will be retained until the piano is switched off.
* When the piano is switched on, C4 will be automatically selected.
* If you split the keyboard during Dual Play, the Tone of the Upper section will be
automatically selected and the corresponding Split Tone will be played.
re ee a ee ae ee EE
15