Roland JV-2080 - Page 14

®ÂØÒÅÎ Supplemental Notes JV-2080 Frequently Asked Questions
Use the following procedure to assign System Controllers
to control the rotary speed on an organ Patch:
1) Press SYSTEM, so it is lit.
2) Press F4[CONTROL] to
display the Control
Assign page (see Fig. 9).
3) Use the CURSOR buttons
to select System Control
1. Here you can assign a
MIDI continuous con-
troller (CC#) such as
CC#16 (General Purpose).
4) Use the VALUE dial to select CC#16.
5) Use the CURSOR buttons to select System Control 2.
Here you can assign a MIDI continuous controller (CC#)
such as CC#74 (Brightness).
6) Use the VALUE dial to select CC#74.
7) Press PATCH.
8) Use the VALUE dial to select Patch PR-A:051 The
Big Spin.
9) Press F5[EFFECTS] to display the Effects page.
10) Press F3[EFX Ctl] to display the EFX Control page.
The two rotary (Leslie speaker) effect parameters
that can be controlled in realtime are speed and level.
11) Use the CURSOR buttons to select MODULATION
(the parameter currently assigned to control the rotary
speed).
12) Use the VALUE dial to select SYS-CTRL1.
13) Assign a slider (or foot pedal) on your keyboard to
transmit controller #16 to the JV-2080; it will con-
trol the rotation speed of the Rotary effect.
©1999 Roland Corporation U.S. JV-2080 Frequently Asked Questions Faxback # 21074 Page 14
FFiigg.. 99
CCoonnttrrooll AAssssiiggnn
PPaaggee
TTiipp
YYoouu ccaann aassssiiggnn bbootthh ssppeeeedd aanndd lleevveell ttoo SSYYSS--
CCTTRRLL11 ssoo tthhaatt wwhheenn yyoouu sseenndd CCCC##1166 ttoo tthhee JJVV--
22008800,, tthhee rroottaarryy ssppeeeedd aanndd lleevveell wwiillll cchhaannggee
ssiimmuullttaanneeoouussllyy..
YYoouu ccaann aallssoo aassssiiggnn tthhee ssyysstteemm ccoonnttrroolllleerrss ttoo
EEFFXX ppaarraammeetteerrss iinn PPeerrffoorrmmaannccee MMooddee aalltthhoouugghh
yyoouu wwiillll nneeeedd ttoo mmaakkee ssuurree tthhaatt tthhee MMIIDDII
rreecceeiivvee cchhaannnneell ffoorr tthhee PPaarrtt yyoouu wwiisshh ttoo eeffffeecctt
iiss tthhee ssaammee aass tthhee CCoonnttrrooll CChhaannnneell..
Using System Controllers (continued)