®ÂØÒÅÎ Supplemental Notes JV-2080 Frequently Asked Questions
The JV-2080 allows some of the internal effect algo-
rithms to be synced with external MIDI clock. For exam-
ple, you can set delay times to sync to the tempo of
your song. This is a real time-saver because it saves you
from having to adjust the settings manually. The JV-
2080s effect settings will be controlled by the tempo of
your sequencer.
Use the following procedure to sync 19:TRIPLE-TAP-
DELAY to an external clock:
1) Press PERFORM.
2) Press F5[EFFECTS] to display the Effects page.
3) Press F2[EFX Prm] to display the Effects Parameter page.
4) Use the CURSOR buttons to select Delay Center.
5) Use the VALUE dial to select e (an eighth note value).
6) Use the CURSOR buttons to select Delay Right.
7) Use the VALUE dial to select e (an eighth note value).
8) Use the CURSOR buttons to select Delay Left.
9) Use the VALUE dial to select x (a sixteenth note
value).
10) Press PERFORM.
11) Press F2[WG] to display the Wave Parameter page.
12) Use the CURSOR buttons to select Clock Source.
13) Use the VALUE dial to select SYSTEM.
14) Press SYSTEM.
15) Press F1[SETUP] to select the Setup parameter
page.
16) Use the CURSOR buttons to select Clock Source.
17) Use the VALUE dial select MIDI.
The following effects can be configured so that they
sync to an external MIDI clock:
16:STEP-FLANGER
19:TRIPLE-TAP-DELAY
20:QUADRUPLE-TAP-DELAY
©1999 Roland Corporation U.S. JV-2080 Frequently Asked Questions Faxback # 21074 Page 9
VIII. How Do I Sync the Effects to an External Clock?
To Next Page
Loading...
Need help?
General
