The Glitch Science Roland JX-305 LCD Replacement Guide
produced by: glitchscience.com 2011©
2014©
Fig. 5 - Electrical tape placed to cover metal edge.
Step 3:
Now you need to remove the original LCD, it is held in place by 4 small phillips
head screws at each corner of the LCD as shown in the Figure 4 photo.
Once the LCD has been removed you will then need to cover the metal edge by
wrapping it with electrical tape. The electrical tape is used in order to insulate the
metal frame from the LCD. See the photo above where the black electrical tape
has been applied on the metal frame edge on the right side of the metal
mounting frame.
To Next Page
Loading...
