Roland M-GS64

i
SE
tes
Section3.individual
Parameter
Transmission
i {Model 1=42H}
i individual Porometer Transmission transmits dota {or requests dota} for one parameter as one exclusive message
tone pocket of °FO..... F7").
{n Individuol Parameter Transmission, you must use the Address und Size listed in the following “Parameter Address
‘Mnp”, Addresses marked at “#” cannot be used as storting addresses.
Address Block Map
The address map for Individual Parameter Tronsmission is os follows.
<dModel 1D = 42H>
KaPor-A
Address( H)Block
00 40 00 +--+
1 SYSTEN |
a ’
20.00 00
‘ FUSER TONE BANK i
i ns
DA 00 pe
| USER DRUM SET I
pe
40 00 06 ++ 5000
FPATCH COMMON #4
40 1000 + 5010004 ~
J PATCH PART = AL TPATCH PART = -B t
1 (BLOCK 00-07) | | {BLOCK 10-18} '
2 ‘ i
4¥ 00 00 +— + 5100.00 + +
(DRUM SETUP A | EDRUM SETUP B |
rt +
' * Blocks delineated by dottad lines { ::: 7] carmot be accessed in Made-1 (Single Module mode),
i * Blocks listed as “#A" ore parameter blocks which are common to the entire device in Mode-t, and valid only for
: Ports ADI -A16 in Mode-2 (Double Moduls mode}
Port-B
Addrass(H) Block
00 40.00 +-————____________-+
: | SYSTEM |
eid eae
' 10.00.00 -¢ an
; USER TOWE BANK t
i GaSe Seiseane
4 21-0000 ——_________
\ USER DRUM SET |
4006.09 —-—————_-—__
ROA I PATCH COMMON = #8 |
——————
40 1000 401000
{PATCH PART A | | PATCH PART 8 i
| (BLOCK 00-0F} I | (BLOCK 10-1F} |
| +
: 51 00.00 + 410000 +
DRUM SETUP A I {DRUM SETUP = B
™ Blocks delineoted by dotted fines { : :::) connot be accessed in Mode-] {Single Module mada).
“ Blocks lisied as “#B” are porameter blocks which ors common to the entire device in Mode-, and valid only for
Ports BO] - 816 in Mode-2 (Double Module mode}.
41