Roland MC-101 - Page 3

MC-101 Update – Functions Added in Ver.1.60
3
Functions Added to the Total Eect
Compressor
Gain reduction meter display added for each band
Release Sync added to each band
(sets the release time following the tempo)
The following items were added to the TOTAL EFFECTS EDIT screen
(COMP tab).
Parameter Value Explanation
High Release Sync
OFF, 1/16, 1/8T, 1/16.,
1/8, 1/4T, 1/8., 1/4
Sets the release time following the
tempo.
Mid Release Sync
OFF, 1/16, 1/8T, 1/16.,
1/8, 1/4T, 1/8., 1/4
Sets the release time following the
tempo.
Low Release Sync
OFF, 1/16, 1/8T, 1/16.,
1/8, 1/4T, 1/8., 1/4
Sets the release time following the
tempo.
Added Shortcuts
Action Operation
Input a tie
In SEQ mode on the drum track, press the [STEP] button while
holding down the [EXIT] button.
Problems and Functions Corrected
5
The time required to save a project has been reduced.
5
The issue with being unable to control scenes 9–128 by receiving
program change messages was xed.
5
The issue with clips being selected when a pad is muted was xed.
5
The issue with preview being unavailable in the sound browser was xed.
5
The issue with the sound not being applied immediately when a sound
le is imported was xed.
5
The issue with irrelevant data (such as clip names) being copied when a
tone is copied was xed.
5
Other textual errors were xed.
5
The issue with the target of the clip to edit being incorrect was xed.
5
The issue with the [OCT+], [OCT-] and [TIE/REST] buttons not working in
CHORD mode when the scale in NOTE mode was set to a value other than
“Chromatic” was xed.
5
When editing steps in CHORD mode, a pad now lights up red if the pad’s
note and the note for the selected step is the same.