MC-101 Update – Functions Added in Ver.1.50
6
User Sample Edit Function Added
We added a function for editing a user sample that was imported to a
tone track or drum track.
For a drum track
1.
Press the [NOTE] button to switch the PAD MODE to NOTE
mode.
2.
Hold down the [SHIFT] button and press the pad [1]–[16]
into which you imported the sample that you want to edit.
The menu appears.
3.
Use the [VALUE] dial to select “SAMPLE EDIT,” and press the
[VALUE] dial.
The user sample edit screen appears.
For a tone track
1.
Hold down the [SHIFT] button and press the [SOUND] button.
The menu appears.
2.
Use the [VALUE] dial to select “SAMPLE EDIT,” and press the
[VALUE] dial.
The user sample edit screen appears.
Parameter Value Explanation
Mode
FWD, ONESHOT, REV,
REV-ONE
Species the playback method.
Start 0–8388607 Species the position at which playback starts.
Loop 0–8388607 Species the loop position.
End 0–8388607 Species the position at which playback ends.
OrgKey C-1–G9 Species the pitch of the sample.
Fine -50.0–50.0 cent Finely adjusts the pitch.
Gain 0 dB, +6 dB, +12 dB Species the approximate volume of the sample.
Level 0–127 Species the volume.
Added Shortcuts
Action Operation
Copy the contents of a
drum kit pad
In a drum track’s NOTE mode, hold down the [SHIFT] button
and press the [FX] button to copy the contents.
Once again hold down the [SHIFT] button and press the [FX]
button to paste the contents.
Paste the contents of a
drum kit pad
Problems and Functions Corrected
5
When using Auto Channel, notes that are input from an external MIDI
device are now output.
5
Fixed the problem in which copying did not occur correctly for STEP 2 in
the step copy/paste function.
5
When recalling a scene, the clip to edit is now also switched.
5
Fixed the problem that had sometimes prevented editing of the BPM
when a looper track’s sample Strtch is set to “OrgBPM.”
5
Fixed the problem in which REC MEAS was sometimes not applied when
a clip is created.
5
Fixed the problem that had sometimes caused freezing when a sample is
previewed.
5
Fixed the problem in which a CC (control change message) sometimes
failed to be output when a track’s knobs ([C1]–[C4]) were operated.
To Next Page
Loading...
Need help?
General
