©2003 Roland Corporation U.S. MC-909 Getting Started Guide Page 17
®ÂØÒňΠMC-909 Getting Started Guide
3. Press F2 (Copy)—the first Copy window appears so you
can select the part from which data is to be copied.
All of the PART buttons at the bottom of the MC-909
light to show that all 16 sequence parts are currently
selected for editing.
When all 16 PART buttons are lit, any edit you perform applies to the entire sequence.
However, we only need to copy Part 10, so let’s select just that one part for editing.
4. Hold down SHIFT and press the Part 10 button so that it’s the only PART button lit.
5. Press F6 (Select)—the second Copy window opens. In
this window, you can set up how Measures 1 and 2
are to be copied. The default settings are fine for our
purposes except for one of them.
6. Press to select the Destination Meas (for
“Destination Measure”) parameter and set it to 3, for
Measure 3. We want to place a copy of Measures 1 and
2 at the beginning of Measure 3 so that the copy fills
up Measures 3 and 4.
7. Finally, let’s make sure we’ll be copying Measures
1 and 2 to the correct part. The PART 10 button is
flashing to show that it’s selected as the destination
for our copied data. This is just what we want, so we’re
good to go.
Don’t do this now, but if you’d wanted to copy Measures 1 and 2 to another part, you’d simply
press the desired part’s button.
8. Press F6 (Execute). The MC-909 displays, “Pattern Edit Completed!”
9. Press PLAY to hear the full four-measure sequence.
10. Press PATTERN to return to the Pattern Play screen.
To Next Page
Loading...
