Using the MV8-OP1
11
MV-8800 Using the MV8-OP1
You can output the audio from the MV-8800’s multi outputs via the R-BUS connector (digital) on MV8-OP1.
1.
Connect the MV-8800 with your output destination device.
2.
Press [MIXER].
The MIXER (AUDIO TRACK) screen (Screen Guide; p. 235) will appear.
3.
Set the Output parameter to MLT1–8 or M1/2–7/8.
Set the Output parameter of the part whose signal you want to send to the multi output bus. The signal sent
to each bus will be output via R-BUS.
Outputting digital audio from R-BUS
Value
Destination bus R-BUS output channel
MLT1
Multi output 1 1
: : :
MLT6 Multi output 6 6
MLT7 Multi output 7 7
MLT8 Multi output 8 8
M1/2 Multi output 1/2 1 and 2
M3/4 Multi output 3/4 3 and 4
M5/6 Multi output 5/6 5 and 6
M7/8 Multi output 7/8 7 and 8
●
The identically-numbered R-BUS and analog multi output will output the same audio.
MV-8800_b_MV8OP1_e.fm 11 ページ ２００６年１２月６日 水曜日 午後１時１１分
To Next Page
Loading...
