Roland STUDIO M - Page 8

2.Starting
up
the
System
After
the MV-30's
power
is turned
on, it must load
its System
Program
from
the
included
System Disk
before
it is able
to
function. This
is
known as
"starting
up
the system".
@@&
-l
o
@
G)
lnsert the
System
Disk into the
disk drive until it clicks
into
place.
Be sure that the disk
is
oriented correctly.
Rear
panel
press
on
The
System
Program will
automatically
be loaded.
When
startup
is
completed, the following
display will appear.
{F1.3;r
---
i
tll
.
tIl
i
tf,l
#'ilffil
Before
you
turn
the
power
on, check
the following
points:
-
Have
all connections
been made correctly?
-
ls
the disk drive
empty?
-
Are the volume levels
on all amplifiers
turned
down?
Turn on the MV-30.
E;c'rr'l
II.
I 1t{E r'E
1 Fl. F i.ttrr, 1
! Fl. P
i EFrcr
2
f, F{.
FiErrr-r
J
fiTHtTh#frHiE*-
@
Turn on
the
power
to the other
equipment connected
to the MV-30.
I
...