Roland V-Accordion FR-1x - System and Other Functions; Auto Off and Speaker Mode; Output Level and USB Data Functions

Orchestra Level
V-Accordion r
55
Auto Off
This parameter allows you to specify
how long the FR-1x should wait before
switching itself off while you are not
using it.
The available options are:
WARNING: Be aware that any unsaved changes are
lost when the FR-1x is switched off by this function. Be
sure to save all important settings as soon as you can
(page 45).
Speaker Mode
When you use the FR-1x for live perfor-
mances and therefore connect it to an
external amplification system, it may be
convenient to switch off the FR-1x’s internal speakers,
because doing so preserves battery power. See also
“Switching off the internal speakers (Speaker Mode)” on
p. 36.
The “Off” setting means that the internal speakers are
off. The “On” setting means that the internal speakers
are active.
Output Level Attenuation
The FR-1x has a level attenuation func-
tion that allows you to adapt its output
level to the audio device you wish to
connect it to. The attenuation value is expressed in dB.
NOTE
This parameter has no effect on the FR-1x’s internal speakers.
Other functions
The following functions are covered in the chapter
“Data management via the FR-1x’s USB port” on p. 40.
■ User Set load
This function allows you to load Sets
from a USB memory to one of the
four internal User memories. See
“Loading User Set memories from USB memory
(optional)” on p. 41.
■ User Set recover
This function allows you to recover
the factory settings of the desired
User Set memory. This function only
loads one set at a time. See also page 64.
■ User Program load
This function allows you to load 10
User Program settings from a USB
memory (provided you have already
saved User Programs to that USB memory). See also
“Loading User Program memories from USB memory
(optional)” on p. 40.
■ Sound Set load
This function allows you to add new
sounds to the FR-1x original sounds.
See “Loading new sounds from a USB
memory (optional)” on p. 42 for details.
■ User Program save
This function allows you to save the
contents of the User Program memo-
ries to a USB memory (optional) con-
nected to the USB port. See “Saving User Program
memories to USB memory (optional)” on p. 40.
Value Off, 1~3
Default setting: 1
Setting Meaning Setting Meaning
Off Disabled 2 15 minutes
1 10 minutes 3 20 minutes
Value Off, On
Default setting: On
Value –12, –6, Off
Default setting: Off
AoF
SP
oLA
Ust
UrC
Upg
Snd
SAv
FR-1x GB.book Page 55 Tuesday, November 8, 2011 11:44 AM