Roland V-Accordion FR-1x - Orchestral and Basic MIDI Settings; Orchestra MIDI Channel and Octave Settings; Basic MIDI Channel Setting

MIDI parameters
V-Accordion
r
61
■ Off
Select this setting if the chord part should neither
receive nor transmit MIDI data.
Chord Octave TX
This parameter allows you to transpose
the Note-on messages transmitted by
the chord buttons up to three octaves
up or down.
Orchestra/Organ TX/RX Channel
This parameter allows you to set the
MIDI channel for the orchestral/organ
part.
■ 1~16
Specifies the orchestral/organ part’s MIDI channel.
■ Off
Select this setting if the treble orchestral/organ part
should neither receive nor transmit MIDI data.
Orchestra/Organ Octave TX
This parameter allows you to transpose
the Note-on messages transmitted by
the Orchestra section.
Orchestra Bass TX/RX Channel
This parameter allows you to define the
MIDI channel for the ORCH BASS part.
■ 1~16
Specifies the orchestral bass part’s MIDI channel.
■ Off
Select this setting if the orchestral bass part should
neither receive nor transmit MIDI data.
Orchestra Bass Octave TX
This parameter allows you to transpose
the Note-on messages transmitted by
the orchestral bass part.
Orchestra Chord TX/RX Channel
This parameter allows you to define the
MIDI channel for the orchestral chord
part.
■ 1~16
Specifies the orchestral chord part’s MIDI channel.
■ Off
Select this setting if the orchestral chord part should
neither receive nor transmit MIDI data.
Orchestra Chord Octave TX
This parameter allows you to transpose
the Note-on messages transmitted by
the orchestral chord part.
Orchestra Free Bass TX/RX Channel
This parameter allows you to define the
MIDI channel for the orchestral Free
Bass part.
■ 1~16
Specifies the orchestral Free Bass part’s MIDI channel.
■ Off
Select this setting if the orchestral Free Bass part
should neither receive nor transmit MIDI data.
Orchestra Free Bass Octave TX
This parameter allows you to transpose
the Note-on messages transmitted by
the orchestral Free Bass part.
Basic Channel TX/RX
This parameter allows you to set the
basic MIDI channel.
The “Basic Channel” can be used for
selecting Sets from an external MIDI device (using pro-
gram change numbers). Please see “MIDI implementa-
tion” on p. 72 for the program change numbers of the
Sets.
The assignment set here applies both to the transmis-
sion (“TX”) and reception (“RX”) of MIDI data.
Value
–3~0~3
Default setting: 0
Value 1~16, Off
Default setting: 4
Value –3~0~3
Default setting: 0
Value 1~16, Off
Default setting: 5
Value –3~0~3
Default setting: 0
Cho
orC
oro
obs
obo
Value
1~16, Off
Default setting: 6
Value –3~0~3
Default setting: 0
Value 1~16, Off
Default setting: 7
Value –3~0~3
Default setting: 0
Value 1~16, Off
Default setting: 13
oCh
oCo
ofb
ofo
bCh
FR-1x_2_GB.fm Page 61 Wednesday, January 4, 2012 12:00 PM