MIDI parameters
V-Accordion
r
63
Bellows TX Resolution
This parameter allows you to specify
how many data the FR-1x’s bellows may
transmit for expression purposes.
■ 1: Represents the highest bellows resolution (double-
byte resolution).
■ 2: Represents a high bellows resolution.
■ 3: Represents the normal bellows resolution.
■ 4: Represents the lowest (coarsest) bellows resolu-
tion.
NOTE
If the external sequencer you work with displays a “MIDI
buffer overflow” message, select a lower resolution. If your
sequencer accepts the complete data amount, use the “4”
setting, because it will lead to even more nuances being
captured.
USB Function driver
The FR-1x’s USB COMPUTER port can be
connected to a USB port on your com-
puter. Doing so allows you to transmit
MIDI data to the computer (which can be recorded
using sequencer software) and to receive MIDI data
from the computer.
Normally, you don’t need to install a driver in order to
connect the FR-1x to your computer. However, if some
problem occurs, or if the performance is poor, using the
Roland original driver may solve the problem.
To do so, first specify the USB driver you want to use
(see below), and then install the driver on your com-
puter. .
NOTE
For details on downloading and installing the Roland original
driver, refer to the Roland website:
http://www.roland.com/
■ Gen (generic)
Choose this if you want to use the standard USB
driver that was included with your computer. Nor-
mally, you should use this mode.
■ Ven (vendor)
Choose this if you want to use a USB driver down-
loaded from the Roland website (www.roland.com).
■ Caution
•To avoid the risk of malfunction and/or damage to
external speakers, always turn the volume all the
way down and switch off the power on all devices
before you make any connections.
• Only MIDI data can be transmitted and received via
USB. Audio data cannot be transmitted or received.
• Switch on the power to the FR-1x before you start
up the MIDI application on your computer. Never
turn the FR-1x’s power on/off while your MIDI
application is running.
Value 1~4
Default setting: 2
Value Gen, Ven
Default setting: Gen
brE
Ufd
FR-1x GB.book Page 63 Tuesday, November 8, 2011 11:44 AM
To Next Page
Loading...
Need help?
General
