Notice originale : Français NT0002 V –p – 03/2014
Loading:
Any damage due to an overloading would in no case been covered by the manufacturer’s
warranty.
. Never exceed the vehicle loading capacity.
. Verify there is a good distribution of the load in the vehicle.
. Verify load balance, its stability as well as vehicle manœuvrability.
. Take care that during loading, no hard body (stone, pieces of wood,
steel, etc.) is loaded in spreader, it might cause damages.
. When used during the freezing period, verify the mobility of conveyor
rods before loading.
Transport
The spreaders are conceived for circulating at 25 km/h or 40 km/h. They are
approved for the road.
Respect the Highway Code.
. Never leave without having checked the vehicle lighting system: your
safety and others’ one depend on that.
. Verify tyre inflation (see chapter Maintenance). Hillside moving of
spreader can be dangerous. As far as possible, move on the direction of slope. Otherwise,
avoid moving with a loading up to 50% of nominal load.
For a maximum safety, it is crucial not to exceed a gradient of 15% (obstacle, rut, and
ditch).
Option of mileage indicator (odometer).
This odometer is configured for a tyre, type 305 70 R 19.5. If your vehicle is equipped with
different tyres, a correction of odometer display is necessary in order to obtain a correct and
exact distance.
Examples of corection values :
Real Value = read value x correction value
For any other dimension, please see on page 40.
To Next Page
Loading...