Rollei super-8 User Manual

edia
oan
Media Loan The Evergreen State College
360.867.6253 Olympia, WA 98505
¸
Please Recycle! rolleisl82 | 07.18.08 | JW
Media Loan Operating Guides are also available online at www.evergreen.edu/media/ml/
Operating Guide for
ROLLEI SUPER-8 CAMERA
BATTERIES
The lm transport as well as the power zoom are
operated by three 1.5 volt "AA" batteries. They
are located in the grip of the camera, which is
easily opened with a small coin. The proper
arrangement of the cells is clearly marked on the
top inside edge of the battery chamber.
To test the condition of the batteries after loading
them into the camera, move the shutter speed
switch to 18, look through the viewnder and
pull the trigger. If a green light appears above
the image in the viewnder, the batteries are
good. If the light ickers, the batteries are nearly
exhausted. If the light does not go on, change
the batteries. In addition to the light signal, the
pointer in the viewnder will not move when the
batteries are exhausted.
CARE OF THE CAMERA
Protect from sand, dust, moisture and 1
prolonged exposure to strong sunlight
or heat.
Keep the external mechanical and 1
optical parts clean.
Use a blower brush and Kodak lens 1
tissue to remove dust and ngerprints
from the lens.
Occasionally clean the lm gate with 1
a blower brush.
Remove the batteries when not using 1
the camera for extended periods of
time.
Keep camera in case when not in 1
use.
BRIEF OPERATING INSTRUCTIONS
Install 3 fresh "AA" Alkaline batteries and then
insert lm cartridge in the cartridge chamber.
Set the lm speed selector to 18 (standard silent
speed). Insert lter key to remove lter when
necessary (see lter key instructions below).
Adjust the viewnder to your eyes using the
diopter and then adjust the focusing ring until
the image in the viewnder is sharp. Lastly, zoom
to desired focal length and begin lming.
LOADING THE CAMERA
Open the cover on the right side of the camera
and insert the lm cartridge. Press down on the
rear edge to snap it into place. Close the cover.
The window in the cover of the cartridge chamber
shows that the camera is loaded and the type of
lm being used.
When there is lm in the camera, the indicator
shows how much lm remains to be exposed. The
lm footage indicator returns automatically to the
"O" position when the lm cartridge is removed
from the camera. When the 50 feet of lm has
run through the cartridge, the word "exposed"
will appear on the lm at the cartridge opening.

Rollei super-8 Specifications

General

Film Format	Super 8
Focus	Manual
Exposure Control	Automatic
Viewfinder	Optical
Power Source	Battery
Film Type	Super 8 cartridge

Summary

Camera Care and Operation

Care of the Camera

Instructions for protecting the camera from environmental factors and maintaining cleanliness of its parts.

Brief Operating Instructions

Step-by-step guide for initial setup and operation, including battery installation and focusing.

Loading the Camera

Procedure for inserting a film cartridge into the camera and checking its status.

Batteries

Details on battery type, location, and how to test their condition for camera operation.

Advanced Camera Functions

Filter Key

Explanation of the built-in conversion filter and how to use the filter key for color correction.

Focusing

Guidance on setting the diopter and focus ring for sharp images at various distances.

Power Zoom

How to use the power zoom lever for smooth focal length changes and manual zoom operation.

Exposure Control

Information on automatic aperture adjustment and indicators for correct exposure levels.

Aperture Lock

Method for overriding automatic exposure control for specific lighting situations.

Using a Cable Release

Instructions on attaching and using cable releases for continuous or single-frame filming.

Shooting with a Tripod

Recommendations for using a tripod for steadier shots and specific filming techniques.

Film Speed

Details on standard (18 fps) and alternative (24 fps) film speeds and their effects.