Fig.
16
Rewinding the
Film
Rewinding thefilm may be
done with the magazine either
attached
to the camera or
removed.
O
Set magazinefunction control
to
8
,
this disengages
the
tronsport and
releases the
pressure plate.
At the same
time the camera
is
switched
off to avoid unintentional
releasing.
O
Fold
out
the rewind handle and turn clocla,pise
until
the catch locates
in to the
rewind
spindle
(fi+.
16).
o
Wind thefilm back until a
light resistance isfelt
caused by the end of theJilm being
held by the clip on
the take
up spool.
Make one more complete
turn of the
rewind handle, this will allow the insert
to
be
easily
removedfrom the magazine and
thevery end of the
filmwill
be leftjust outside the cassette.
Note: AllJilm is liable
to be affected by extremes of
tem-
perature
and
humidity. It is therefore a
wise
precaution
to
protect
loaded magazinesfrom
such extremes, especially
by
keeping the magazine and/or
the whole camera watrn
where the
ambiant
temperature is below
0 degrees C.
ColdJilm isvery brittle
and tears easily.
14
To Next Page
Loading...
