C
50 000 kilometres (30 000
miles)
or
21/2
years
service
whichever
is
the
earlier
Essential
Maintenance
Engine
Change the engine oi
I.
Fit
a new oi I
filter.
Battery
Check the level
of
the
electrolyte
and
if
necessary,
top-up
with
distilled
water.
Belt tension
Check the tension
of
all
driving
belts,
reset
if
necessary.
Brakes
Inspect the footbrake and parking brake pad I
inings,
fit
new
linings
if
necessary.
When
changing the
footbrake pads examine the condition of the dust
excl uders
on
the calipers; renew
if
necessary.
Manually adjust the parking brake pads.
Inspect
all
brake pipes and connections; the
Distributor/Retailer
should report any defects to the
Owner.
Fluid
levels
Check al I
fluid
levels
and correct
if
necessary.
Preventive
Maintenance
Carburetters
Top-up the
oil
level
in
the
air
valve
dampers.
Control linkages
Apply a few drops
of
engine oi I to the accelerator
Ii nkage and to the gear range selector
controls
adjacent to the transmission casing.
Electrical system
Check al I
interior
lamps, exterior lamps, instruments,
warning lamps and devices for correct operation;
rectify
if
necessary.
Parking brake I inkage
Lubricate
the
pivot
pins and
pulleys
in
the parking
brake system
with
approved grease.
Tyres
Check and tread depth of al I tyres,
inspect
al I
tyres
for
signs
of
damage. Check the tyre pressures when
they are cold and
adjust
if
necessary.
Note
Include the spare tyre.
Test
Road
test
the car for
satisfactory
performance.
60
000
kilometres
(36
000
miles)
or
3
years
service
whichever
is
the
earlier
Essential
Maintenance
Air
injection
pump
Check the
be!
t tension and reset
if
necessary.
Air
silencer
Fit
a new
air
filter
element.
Carburetters
Top-up the
oil
level in the
air
valve
dampers. Check
the
float
chamber depression and
rectify
if
necessary. Check the
idle
speed and
rectify
if
necessary. Check the choke
fast-idle
speed and
rectify
if necessary.
Crankcase emission control system
Clean the gauze flame traps
in
the crankcase
breather tube. Clean the adapter
in
the choke
butterfly housing.
Engine
Change the engine oi
I.
Fit
a new oi I ti I ter.
Exhaust manifolds
Check the torque tightness of the exhaust manifold
bolts.
Fuel evaporation emission control system
Check the condition of the pipes and connections;
rectify
if
necessary.
Ignition system
Fit
new sparking plugs ensuring that the gaps are
correctly
set.
Lubricate
the di
stri
bu
tor
spindle
{shaft bearings) and automat.ic advance mechanism
with
engine
oil.
Check the
ignition
timing and
reset
if
necessary.
Battery
Check the level
of
the
electrolyte
and
if
necessary,
top~p
with
distilled
water.
Be It tens
ion
Check the tension
of
all
driving
belts
and reset
if
necessary.
Brakes
Inspect the footbrake and parking brake pad
linings;
fit
new
linings
if necessary.
When
changing
foot-
brake pads examine the condition
of
the dust
excl uders
on
the ca Ii pers; renew
if
necessary.
Manually
adjust
the parking brake pads.
Inspect
all
brake pipes and connections; the
Di stri but
or/
Retai I
er
should report any defects to
the Owner.
Fluid
levels
Check
all
fluid
levels
and correct if necessary.
Front suspension
Inspect the front suspension bal I
joint
rubber
covers, if the covers are found to be damaged,
fit
new
joints
and covers.
E13 - 5
To Next Page
Loading...
