Reset
if
necessary the engine
idling
speed.
9. Control
linkages:
Apply a few drops
of
engine
oil
to
the
accelerator
linkages
and
to
the gear range
selector
controls
adjacent to the gearbox casing.
10.
Electrical
system: Check that
all
lamps,
instruments and
air
conditioning
controls are
operating
satisfactorily;
rectify
as necessary.
i-11.
Ignition
system: Check and
if
necessary adjust
the
distributor
dwel I angle.
Check
the
ignition
timing
and
adjust
if
necessary.
12.
Propeller
shaft: Examine the neoprene seal at
the front end
of
the
shaft
for
serviceability.
13. Servo: .Check
and
if
necessary
adjust
the servo.
14. Wheels and
tyres:
Check and
if
necessary
adjust
the
tyre
pressures.
Inspect
the
tread depth
of
all
tyres;
also
inspect
the
tyres
for
damage. Report any
defects
to
the Owner.
Check and
if
necessary balance
the
wheels.
15. Check the
fol
lowing
levels:
Check the
fluid
level
in
the
steering
pump
reservoir
and top-up
if
necessary.
Check
the
level
and
specific
gravity
of
the
engine
coolant
and
correct
if
necessary.
Check
the
fluid
level
in
the
windscreen washer
reservoir
and top-up
if
necessary.
16.
Test:
Road
test
the
car
for
satisfactory
performance.
Every 20 000 kilometres (12 000 milles}
or
12
months
whichever
is
the earlier
·t1.
Air
injection
pump
(Applicable
to
cars from
Car Serial number
PRH
4613): Check the
tension
of
the
belt
driving
the
air
injection
pump;
adjust
if
necessary.
*+2.
Air
injection
pump
intake
filter
(Applicable
to
the
three
vane type
only):
Remove and clean the
intake
filter
element.
•t3.
Air
silencer
and cleaner: Remove and clean
the
wire
mesh
filter
element.
• 4.
Automatic
gearbox: Check
the
fluid
level
and
top·up
if
necessary.
•_
5.
Battery:
Check
the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
• 6.
Brakes:
Remove
the
brake drums and
inspect
linings
for
wear; renew
linings
if
necessary.
Check
and
if
necessary
adjust
the
rear brakes.
Check the
fluid
I evel
in
the brake
reservoir
and top-up
if
necessary.
•
7.
Brake
master
cylinder:
Lubricate
the
grease
nipple
on
the
master
cylinder
balance
lever.
•ta. Carburetter: Top-up oi I
level
in
air
valve
dampers.
Ensure
tightness
of
float
chamber
covers
is
correct.
If
wire
mesh
filters
are
fitted
to
the
float
chambers remove
the
unions
and clean
the
filters.
Check
the
float
chamber depression and
rectify
if
necessary.
Check
engine
idle
speed and choke
fast
idle
speed;
adjust
as
necessary.
·
*t9.
Crankcase
emission
control
system: Remove and
clean
the
gauze flame traps
in
the crankcase
breather
tube.
D4 - 2
Clean the adapter
in
the choke
butterfly
housing.
·t10.
Engine: Change the engine
oil
and
fit
a new
oil
filter
element.
• 11.
Final
drive
unit:
Check
the
oil
level
and top-up
if necessary.
* 12.
Front
suspension:
Lubricate
the
eight
grease
nipples
on
the
front
suspension.
*
t13.
Fuel
evaporation emission
control
system
(Applicable
to
cars from Car serial number
PRH
4801): Check
the
condition
of
pipes
and
connections.
*t14.
Ignition
system:
Fit
new
distributor
contact
breaker
points;
set
dwell
angle.
Fit
a new
distributor
cam
lubrication
pad
(if
applicable).
If
a
cam
lubrication
pad
is
not
fitted
lightly
smear the
cam
with
grease.
Lubricate
the
distributor
spindle
{shaft
bearings) and automatic advance mechanism
with
clean engine
oil.
Fit
new
sparking plugs.
Check operation
of
vacuum
retard
tap
(if
fitted).
Check
ignition
timing
with
stroboscope and
adjust
if
necessary.
*
15.
Propel I
er
shaft:
Lubricate
the grease
nipple
in
the
centre
and rear universal
joints
and
the
sliding
joint.
•
16.
Steering mechanism:
Lubricate
the
thirteen
grease
nipples
with
the
approved grease.
17.
Belts
and
belt
tension:
Check
the
condition
and tension
of
the
belts
driving
the
coolant
pump,
steering
pump, and refrigeration compressor and
the
alternator,
adjust
or
replace as
necessary.
18.
Brake
linkage:
Lubricate
the
brake I inkage
clevis
and
fulcrum
pins
of
the
pull
rods and
inter·
mediate
levers.
19. Control
linkages:
Apply
a
few
drops
of
engine
oil
to
the
accelerator
linkage
and
to
the
gear range
selector
controls
adjacent
to
the
gearbox
casing.
20.
Electrical
system: Ensure
that
al
I I amps,
instruments and
air
conditioning
controls
are
operating satisfactorily.
21. Handbrake
linkage:
Lubricate
the
pivot
pins
and
pulleys
in
the
handbrake system
with
the
approved grease.
22. Rear fuel
tilter:
Remove
the
gauzes and clean
them. Drain and
clean
the
filter
bowl.
23. Servo: Check and
if
necessary
adjust
the
servo.
24. Shock dampers: Check
for
signs
of
fluid
leaks;
if apparent
inspect
the
fluid
level
and
if
necessary top-up
with
the
approved
fluid.
25. Wheels and
tyres:
Check and
if
necessary
adjust
the
tyre
pressures.
Inspect
the
tread depth
of
all
tyres;
also
inspect
the
tyres
for
damage. Report any
defects
to
the
Owner.
Check and
if
necessary
balance
the
wheels.
26. Check the
following
levels:
Check
the
fluid
level
in
the power
steering
pump
reservoir
and top-up
if necessary.
Check the
level
and
specific
gravity
of
the
engine
coolant
and
correct
if
necessary.
Check
the
fluid
level
in
the
windscreen
washer
reservoir;
top-up
if
necessary.
27.
Test:
Road
test
the
car
for
satisfactory
pert
or
man
ce.
To Next Page
Loading...
