Check
the
level and specific gravity
of
the
engine
coolant and correct if necessary.
Run the engine for
four
minutes
then
check
the
fluid levels
of
the
hydraulic braking systems reservoirs;
top-up if necessary with the approved fluid.
Check
the
fluid level in
the
windscreen washer
reservoir and top-up if necessary.
15.
Test: Road test
the
car for satisfactory
performance.
'B'
Service Schedule • Every 20
000
kilometres
(12
000
miles) or
12
months whichever
is
the
earlier
*t1.
Air silencer and filter: Remove and clean
the
wire
mesh filter element.
*
2.
Battery: Check
the
electrolyte level; top-up with
distilled water if necessary.
*
3.
Brakes: Remove the brake drums and inspect
linings for wear; renew linings if necessary.
Check and if necessary adjust the rear brakes.
Inspect pipes and connections. Report any defects
to
the
Owner.
*t4.
Carburetters: Check
the
oil level
in
the air valve
dampers and if necessary top-up
to
correct level.
Check float chamber depression and rectify if
necessary.
Check
the
engine idle speed and choke idle speed;
adjust if necessary.
Ensure exhaust emissions comply with E.C.E.
Regulation 15, if applicable.
*
5.
Engine: Change engine oil and
fit
a new oil filter.
"t6. Engine breather system: Remove and clean
the
flame traps
in
the
crankcase breather tube and also
clean the adapter
in
the
choke butterfly housing.
* 7. Final drive unit: Check
the
oil level and top-up jf
necessary.
*
8.
Front
suspension: Lubricate the eight grease
nipples on
the
front suspension with
the
approved grease.
"t9.
Ignition system: Lubricate
the
distributor spindle
(shaft bearings) with clean engine oil.
Fit new sparking plugs.
Check ignition timing with stroboscope and adjust
if necessary.
*10. Steering mechanism: Lubricate
the
thirteen grease
nipples with
the
approved grease. Inspect
the
rubber
covers
on
the
ball joints; if
the
covers are damaged
the
joints should be dismantled and new parts fitted as
necessary.
*
11
. Torque converter transmission: Change
transmission fluid.
12. Belts and belt tension: Check the condition and
tension
of
the
alternator, coolant
pump
and steering
pump/refrigeration compressor driving belts; adjust
or
replace as necessary.
13. Brake linkage: Lubricate
the
brake linkage clevis
and fulcrum pins
of
the
pull rods and intermediate levers
with
the
approved grease.
14. Control linkages: Lubricate the accelerator linkage
and
the
gear range selector controls (adjacent
to
the
transmission casing) with clean engine oil.
D6·2
15. Electrical system: Check all exterior lamps, interior
lamps, warning lamps and devices, and instruments for
correct operation; rectify
as
necessary.
16. Parking brake linkage: Lubricate
the
pivot pins,
pulleys and inner cable with
the
approved grease.
17. Shock dampers: Check fluid levels and top-up if
necessary with approved fluid. Inspect
the
dampers for
fluid leaks and report any defects
to
the
Owner.
18. Wheels and tyres: Check and if necessary adjust
the
tyre pressures.
Inspect
the
tread
depth
of
all tyres; also inspect
the
tyres for damage. Report any defects
to
the
Owner.
Check and if necessary balance
the
wheels.
19. Check
the
following levels: Check
the
fluid level
in
the
power steering pump reservoir and top-up if
necessary.
Check
the
level and specific gravity
of
the
engine
coolant and correct
if
necessary.
Run
the
engine for
four
minutes
then
check
the
fluid levels
of
the
hydraulic systems reservoirs; top•up
if necessary with
the
approved fluid.
Check the fluid level
in
the
windscreen washer
reservoir; top-up if necessary.
20. Test: Road test the car for satisfactory
performance.
'C'
Service Schedule· Every
40
000
kilometres
(24
000
miles)
or
2 years whichever
is
the
earlier
*t1.
Air silencer and filter: Remove and clean
the
wire
mesh filter element.
*t2.
Automatic choke: Check the flow through the
choke stove pipe and check for correct functioning;
rectify if necessary.
*
3.
Battery: Check
the
electrolyte level; top-up with
distilled water if necessary.
*
4.
Brakes: Remove
the
brake drums and inspect
linings for wear; renew linings if necessary.
Check and if necessary adjust
the
rear brakes.
Inspect pipes and connections. Report any defects
to
the
Owner.
*t5.
Carburetters: Clean
the
air valves;
top-up
the
oil
level
in
the
air valve dampers.
Fit new paper element filters
to
the
fuel inlet
connections.
Check float chamber depression and rectify if
necessary.
Check engine idle speed and choke idle speed;
adjust as necessary.
Ensure exhaust emissions comply with E.C.E.
Regulation 15, if applicable.
* 6. Engine: Change
th.e
engine oil and
fit
a new oil
filter.
*t7.
Engine breather system: Remove and clean
the
gauze flame traps
in
the
crankcase breather
tube.
Clean
the
adapter in
the
choke
butterfly housing.
*
8.
Engine cooling system:
Fit
a new engine coolant
thermostat.
Examine
the
condition
of
all hoses; fit new hoses
as necessary. Fit new heater
tap
hoses (irrespective
of
visual appearance).
u
To Next Page
Loading...
