,,
c;
v:i
I-
Certain items
in
these schedules are marked
with
an
asterisk
ri. The
servicing
for
these items
should
be
carried out at the periods
specified
in
order
to
comply
with
the Rolls-Royce Motors New
Car Warranty during the Warranty period,
In order to comply
with
the relevant Emission
Control Regulations items marked thus
(t)
must be
carried out during the
entire
service
life
of the
vehicle.
Regular Maintenance
1. Battery (Not
applicable
to cars
fitted
with
the
Dagenite
Autofil
or Dagenite
Demon
battery):
Weekly, check the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
2. Engine: Weekly or every 800 kilometres
(500 miles}, whichever
is
the
earlier
check
the oi I
level
by
means of the
dipstick;
top-up
if
necessary.
3.
Lamp
units:
Weekly, check the lamp
bulbs
for
correct operation and replace any
faulty
bulbs.
4. Tyre pressures: Weekly, check the
tyre
pressures,
including
the spare; adjust
if
necessary.
5.
Windscreen washer reservoir: Weekly, check
the
f I ui d level; top-up
if
necessary.
6.
Carburetters: Monthly,
check
the
oil
level
in
the
reservoir
of
the automatic
air
valve dampers; top-up
if
necessary.
7.
Hydraulic
reservoirs: Monthly, check the
level
of
fluid
in the reservoirs; the engine should be run
for four minutes before checking the
fluid
level.
Top-up
if
necessary to
the
indicated
level.
If
frequent topping-up
is
necessary check the hydrau
Ii
c
system for leaks
and
rectify
as necessary.
8. Engine
cooling
system: Every three months,
check the level
of
coolant
in
the radiator header
tank, if necessary, top-up with the correct
anti-
freeze/ water mixture.
Initial
Service - 5
000
kilometres (3 000
miles)
or
3
months
whichever
is
the earlier
·t1.
Air
injection
pump: Check the tension
of
the
belt
driving the
air
injection
pump
and
adjust
if
necessary.
•i2.
Automatic choke: Check the
flow
through the
choke stove pipe and check for correct operation.
Rectify
as necessary.
•+3. Carburetters: Check the oi I level
in
air
valve
dampers and
if
necessary top-up to the correct
level.
Check tightness of
float
chamber
covers.
Check
float
chamber depression and
rectify
if necessary.
Check
and
if
necessary reset the i
die
speed.
Check
and
if
necessary
rese1
the choke
fast-
idle
speed.
·+
4. Engine: Change engine
oil.
·ts. Engine
cooling
system:
Tighten
the
worm
drive
clips
securing
all
coolant hoses.
Section
E4
Silver Shadow, T Series, Corniche
and Camargue cars built up
to
and including
the
1975
Japanese specification
·to. Exhaust gas
recirculation
system: Check the
exhaust gas
recirculation
valve
for
correct operation.
•
t7.
Fuel evaporation emission control system:
Check the purge rate;
this
should be between
1,41 cu.
m.
per hr.
and
1,98 cu.
m.
per hr.(50 cu.
ft.
per hr. and
70
cu.
ft.
per hr.) at 600 r.p.m.
in
neutral.
Fit
a new purge
line
filter
if
necessary.
Pressure test
the
fuel tank and evaporation
loss
line
and
if
necessary
rectify
any leaks.
·ts.
Ignition
system: Check the
ignition
timing
and
dwell
angle;
adjust
if
necessary.
•
9.
Torque converter transmission: Check
the
fluid
level
with
the engine running
and
top-up
if
necessary.
When
checking the
fluid
level,
avoid
contact with the exhaust gas recirculation
valve,
heat shield and associated
pipes
as these
components
wi
11
be hot.
10.
Belts
and
belt
tension: Check the
condition
and
tension of the
belts
driving
the cool ant pump,
steering
pump
and
refrigeration
compressor, and the
alternator; adjust
or
replace as necessary.
11. Steering pump: Check the
fluid
levei in the
steering
pump
reservoirs: top-up
if
necessary.
12. Test: Road
test
the car for satisfactory
performance.
Every 5 000 kilometres
(3
000
miles)
or
3
months
whichever
is
the earlier
•
1.
Engine:
If
the
car
is
used
for
constant
stop/
start operation, change the engine lubricating
oil.
Every 10 000 kilometres (6 000 miles) or 6
months
whichever
is
the earlier
•
1.
Battery: Check the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
•
2.
Brakes: Inspect footbrake
and
handbrake
or
parking brake pad
linings;
fit
new pads if necessary.
When
renewing footbrake pads examine condition of
dust exc luders
on
calipers
and renew
if
necessary.
Manually
adjust
the handbrake or parking
brake
caliper
mechanism.
Inspect al I pipes and connections. Report any
defects to the Owner.
•
t3.
Engine: Change the engine oi I
and
fit
a new
oi I
filter
element.
*t4.
Ignition
system (1973 and 1974 model year
cars): Check the system
with
an
ignition
analyser.
If
necessary clean the sparking plugs and reset the
gaps.
• 5. Torque converter transmission
(If
fitted):
Check the
fluid
level
with
the engine running and
top-up
if
necessary.
On
1973/74
and
1975 model year cars, when
checking the
fluid
level
avoid contact with the
exhaust gas
recirculation
valve,
heat
shield
and
associated pipes as these components
wi
11
be
hot.
6. Automatic gearbox
(If
fitted):
Check the
fluid
level
and
top-up
if
necessary.
E4
- 1
To Next Page
Loading...
