C:
/
alternator; adjust or replace as necessary.
19. Control
Ii
nkages:
Lubricate
the accelerator
linkage
and
the gear range
selector
controls
(adjacent to the transmission casing)
with
engine
oi
I.
20.
Electrical
system: Check al I
exterior
lamps,
interior
lamps, warning lamps and
devices,
instruments and
air
conditioning
controls
for correct
opera
ti on;
rectify
as necessary.
21.
Handbrake
and
Parking
brake I inkage:
Lubricate
the
pivot
pins
and
pulleys
with
approved grease.
22. Propeller
shaft
(Cars
fitted
with the four
speed automatic gearbox): Examine the neoprene
seal at the front end
of
the
shaft
for
servi ceabi Ii ty;
rectify
as necessary.
23.
Spare
wheel
carrier:
Lubricate
the spare wheel
carrier lowering
bolt
and
mechanism.
24. Check the
fol
lowing
I evel s and pressures:
Check the
fluid
level in
the
steering
pump
reservoir;
top-up
if
necessary.
Check the
fluid
level
in the steering
idler
box damper; top-up
if
necessary.
Check the level and
specific
gravity
of the
engine coolant; correct as necessary.
Check the
fluid
level
in
the windscreen
washer reservoir
and
top-up if necessary.
Run
the engine for four minutes then check
the I eve Is
of
the hydrau
Ii
c systems reservoirs;
top-up
if
necessary
with
recommended
fluid.
Check
and
if
necessary
adjust
the tyre
pres$ures. Inspect the tread depth of
all
tyres;
also
inspe'ct the tyres
for
damage. Report any defects to
the Ow'ner.
25. Test: Road
test
the
car
for
satisfactory
pen
ormance.
Every
40
000 kilometres (24 000 miles)
or
2
year&
whichever
is
the earlier
In addition to the
20
000
kilometres
( 12 000 miles)
service
schedule carry
out
the
fol
I owing.
In the case
of
Carburetters,
Final
drive
unit,
Fuel evaporation emission control system,
Propeller
shaft and the Torque converter transmission
the servicing necessary
is
I
isted
in
this
schedule
therefore, the
20
000
kilometres
(12 000 miles)
service
schedule should not
be
consulted for these
items.
•
1.
Air
injection
system (From Car
serial
number
SRH
8055
and
onwards
i.e.
from 1969 model year
cars): Check the
air
injection
system
for
leaks
and
correct functioning;
rectify
if necessary.
"t2.
Automatic choke: Check the
flow
through the
choke stove pipe
and
check
for
correct function;
correct as necessary.
-t-3, Carburetters: Clean the
air
valve
pistons.
Top-up the
air
valve dampers
with
new engine
oil.
Fit
new paper element
filters
to
the
float
chamber
inlet
connections
(if
applicable).
Check and
if
necessary
adjust
float
chamber
depression.
Check engine
idle
speed
and
choke
fast-idle
speed; adjust as necessary.
• 4. Engine cooling system:
Fit
a new thermostat.
Examine the con di ti on of
a
11
hoses;
fit
new hose!l
if
necessary.
Fit
new heater tap hoses
(irrespective
of
visual
appearance).
•
5.
Final
drive
unit:
Change the oi
I.
*t6. Fuel evaporation emission control system ( From
Car serial number
SRH
14806 and onwards):
Fit
a
new
foam
filter
element
in
the evaporation loss
control canister. Check the
condition
of the pipes
and
connections. Check the purge rate;
this
should
be
between 1,41 cu.
m.
per
hr.
and 1,98 cu.
m.
per hr.
(50
cu.
ft.
per hr. and
70
cu.
ft.
per hr.) at 600
r.p.m. in neutral. Renew the purge
line
filter
if
necessary.
*T7.
Fuel mixture weakening
device
filter
(From
Car serial number
SRH
8055 and onwards
i.e.
from
1969 model year cars):
Fit
a new fuel mixture
weakening device
filter.
• 8. Torque converter transmission (If
fitted):
Change the transmission
fluid
and
fit
a new intake
strainer.
Renew 'O' rings on
intake
pipe
and
fit
a
new seal to bore
of
intake
strainer.
On
1973/7
4
and
1975 model year cars. when
checking the
fluid
level,
avoid contact with the
exhaust gas recirculation
valve,
heat
shield,
and
associated pipes as these components
wi
11
be hot.
9. Dynamo
(If
fitted):
Check the brushes for wear
and
for
freedom in their ho! ders;
fit
new brushes
if
necessary.
10. Fuel
filter:
Clean out the
filter
bowl and
fit
a new
filter
element.
11.
Fuel pumps: Remove pumps and
test
fuel pump
efficiency;
fit
new pumps
if
necessary.
12. Fuel tank: Release the fuel tank drain plug
and
al low any accumulated water to drain away;
fit
the drain plug
and add
four S.B.N.
inhibitors
to the
tank.
13.
Height
control mechanism: Disconnect, clean
and
1 ubri
cate
the height con tro I valve bal 1
joints;
connect bal 1
joints.
14. Power operated hood (If
fitted):
Check the
level
of
fluid
in
the reservoir; top-up
if
necessary.
15. Prope
lier
shaft
( Cars f i tied with four speed
automatic gearbox): Examine the neoprene seal at
the
front
end of the
shaft
for
serviceability;
rectify
as necessary.
Examine the rear
joint
for signs
of
grease
leakage;
rectify
as necessary.
Check the torque tightness
of
the
bolts
securing the front
and
rear
joints;
rectify
as
necessary.
16. Rear wheel
drive-shafts:
Lubricate
the outer
universal
joints
with
approved grease.
17. Steering pump (Hobourn Eaton): Renew the
filter
element in the steering
pump
reservoir •
Every
60 000
kilometres
(36 000
miles)
or 3
years whichever
is
the earlier
In addition
to
the
20
000 kilometres (
12
000 miles)
and the
40
000 kilometres (24 000 miles) service
schedules carry out the fol lowing.
1.
Wax
capsule type fuel mixture weakening
device
cut-off
valve
(If
fitted):
Fit
the
later
type
thermal
switch
assembly.
E4 - 3
To Next Page
Loading...
