•
s•
Service Schedule - Every 20 000 kilometres
(12 000 miles)
or
12
months
whichever is the
earlier
·t1.
Air
filter/silencer:
Fit
a new
filter
element.
• 2.
Battery:
Check the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
•
3.
Brakes: Inspect the footbrake and handbrake
or
parking brake pad
linings;
fit
new pads
if
necessary.
When
renewing brake pads,
e><amine
the
caliper
dust
excluders and renew
if
necessary.
Manually
adjust
the handbrake/parking brake
caliper
mechanism.
Inspect
pipes
and connections. Report any
defects to
the
Owner.
•
t4.
Carburetters: Check the
air
valve
damper oi I
levels
and top-up
if
necessary
also,
check and
adjust
the
float
chamber depression (SU
carburetters
only).
Check the engine
idle
speed
and
choke
idle
speed;
adjust
if
necessary.
Ensure exhaust emissions comply
with
E.C.E.
Regulation 15,
if
applicable.
•
5.
Engine: Change engine oi 1 and
fit
a new oi I
filter.
't6.
Engine breather system: Remove and clean
the gauze flame trap
in
the crankcase breather tube.
Clean the adapter
in
the choke
butterfly
housing
(SU carburetters) or the breather connection in the
air
filter
housing (Sol ex carburetters).
•
7.
Final
drive
unit:
Check the
oil
level;
top-up
if
necessary.
•
8.
Front suspension: Inspect the front
suspension
ball
joint
rubber covers;
if
the covers
are damaged,
fit
new
joints
and covers.
·t9.
Ignition
system:
Lubricate
the
distributor
spindle
(shaft
bearings) and automatic advance
mechanism
with
clean engine
oil.
Fit
new sparking plugs.
Check
ignition
timing
with
stroboscope and
adjust
if
necessary.
• 10. Steering mechanism:
Lubricate
the steering
mechanism at the
six
grease points. Inspect the
rubber covers on the
ball
joints;
if
the covers are
damaged the
joints
should
be
dismantled and new
parts
fitted
as necessary.
• 11. Torque converter transmission: Change
trans miss ion
f I u
id.
12.
Belts
and
belt
tension: Check the
condition
and tension of the
coolant
pump, steering pump and
refrigeration compressor, and alternator
driving
belts;
adjust
or
replace as necessary.
13.
Control
linkages:
Lubricate
the
accelerator
I inkage and the gear range
selector
controls
(adjacent to the transmission casing)
with
engine
oil.
14.
Electrical
system: Check
all
exterior
lamps,
interior
lamps, warning lamps
and
devices,
and
instruments for correct operation;
rectify
as
necessary.
15.
Handbrake or Parking brake I inkage:
Lubricate
the
pivot
pins and
pulleys
with
approved grease.
16. Spare wheel carrier:
Lubricate
the spare wheel
carrier
lowering
bolt
and mechanism.
17.
Levels
!:Ind
pressures: Check the
fluid
level
of
the steering
pump
reservoir; top-up
if
necessary.
E7
- 2
Check the f I u
id
I eve I
of
the
steering
idler
bo><
damper; top-up
if
necessary.
Check the level and
specific
gravity
of
the
engine coolant; correct
if
necessary.
Check the
fluid
level
in
the windscreen washer
reservoir and top-up
if
necessary.
Run
the engine for four minutes then check the
levels
of
the
hydraulic
systems reservoirs; top-up
if
necessary.
Check and adjust
all
tyre pressures;
also
check
tyre
tread depth
and
condition
of
tyres. Report
any
defects
to
the Owner.
18.
Test:
Road
test
the
car
for
satisfactory
performance.
•
C'
Service Schedule - Every 40 000 kilometres
(24 000 miles)
or
2 years whichever
is
the
earlier
In
addition
to the
20
000
kilometres (12
000
miles)
service
schedule carry out the
following.
In
the
case of
the
Carburetters,
Final
drive
unit,
Torque converter transmission and
Levels
and
pressures,
servicing
necessary
is
I
isted
in
this
schedule therefore, the
20
000
ki I ometres
{12
000
miles)
service
schedule should not be
consulted
for
these items.
·t1.
Automatic
choke: Check
flow
through
the
choke stove pipe and check
for
correct function;
correct
as necessary (SU carburetters
only).
• t2. Carburetters: Clean the
air
valve
pistons.
Top-up the
air
valves
with
new engine oi L
Fit
new
paper element
filters
to the
float
chamber
inlet
connections. Check and
adjust
float
chamber
depression
(SU carburetters
only).
Check engine
idle
speed and choke
idle
speed;
adjust
as necessary.
Ensure exhaust emissions comply
with
E.C.E.
Regulation 15,
if
applicable.
*
3.
Engine
cooling
system:
Fit
a new thermostat.
Examine the
condition
of
all
hoses:
fit
new hoses
as necessary.
Fit
new heater tap hoses
(irrespective
of
visual
appearance).
• 4.
Final
drive
unit:
Change the
oil.
·ts.
Fuel
mixture weakening device:
Fit
a new
fuel mixture weakening
device
filter
(SU
carburetters
only).
*
6.
Torque converter transmission: Change the
transmission
fluid
and
fit
a new
intake
strainer.
Renew·
O'
ring on
intake
pipe and
fit
a new seal to
bore of
intake
strainer.
7.
Fuel
filter:
Clean out the
filter
bowl and
fit
c1
new ti 1 ter element.
8.
Fuel
pumps: Remove pumps and
test
fuel
pump
efficiency;
fit
new pumps
if
necessary.
9.
Fuel
tank: Release the fuel tank
drain
plug
and
allow
any accumulated water to
drain
away;
fit
the
drain
plug
and add four S.B.N.
inhibitors
to the
tank.
10.
Height
control mechanism: Disconnect, clean
and
l:;bricate
the
height
control
valve
ball
joints;
connect
ball
joints.
11. Rear wheel
drive-shafts:
Lubricate
the outer
uni versa I
joints
with
approved grease.
To Next Page
Loading...
