Farking brake linkage
Lubricate
the
pivot
pins
and
pulleys
in
the parking
brake system
with
approved grease.
Spare
wheel carrier
Lubricate
the spare wheel
carrier
I oweri
ng
bolt
and
mechanism.
Tyres
Check the tread depth
of
all
tyres, inspect
all
tyres for signs
of
damage. Check the tyre pressures
when they are cold and
adjust
if
necessary.
Note
Include the spare tyre.
Test
Road
test
the
car
for
satisfactory
performance.
Seasonal Schedules
Every
12 months
Engine cooling system
Drain
the
coolant
from
radiator
and engine
crankcase.
Fi
II
with
the correct anti-freeze mixture.
Ensure that the
flow
of
coolant
through the
heater tap feed hose wi
11
not be
restricted
by a
sharp radius
or
bend
in
the hose, by the hose
contacting other adjacent pipework
or
by poor
alignment.
Clean any debris from the surfaces
of
the
refrigeration condenser and radiator matrices by
reverse
flushing
with
a hose.
This
should be
carried out
just
prior
to
the autumn.
Body
drain holes
Check that the body drain
holes
are unobstructed.
Air conditioning system
Check
that
the foam
filter
element(s)
fitted
to the
scuttle
intake
gri I
le
is
free from obstruction.
Refrigeration system
Check the refrigeration system
for
correct operation,
rectify
if
necessary. Any work must
be
carried out
by
an
experienced engineer.
Every 2 years
In addition to
12
monthly seasonal schedule,
carry out the
following
operation.
Engine cooling system
When
the cool ant has been drained, thorough I y
reverse flush the
coolant
passages
with
a con-
tinuous
flow
of
water.
Fit
new hoses where
necessary.
E19 - 10
Service Recommendations
For convenience these
services
may
be carried out
at
the brake pad renewal nearest to the
specified
mileage.
Every 80 000 kilometres (48 000 miles}
At
this
mileage under normal motoring
conditions
it
is
recommended that
the
fol lowing
servicing
is
carried out.
Automatic height control and braking systems
Examine the sub-frame to brake
caliper
hoses
for
chafing or surface cracking; renew
if
necessary.
Fit
new front and rear accumulator to frame hoses.
Every 160 000 kilometres (96 000 miles}
At
this
mileage under normal motoring
conditions
it
is
recommended that the
following
service
is
carried out.
Automatic height control
and
braking systems
Fit
all
new
flexible
hOses to the braking systems
and automatic
height
control system.
Fit
new seals to the
disc
brake
calipers
and the
deceleration conscious pressure
limiting
valve.
Fuel system
Fit
a new convoluted rubber hose between the fuel
filler
head and fuel tank assembly.
Examine
all
flexible
fuel
pipes
and renew any
which show signs
of
deterioration.
To Next Page
Loading...
