Farking brake linkage
Lubricate
the
pivot
pins
and
pulleys
in the parking
brake system
with
approved grease.
Spare wheel carrier
Lubricate
the spare wheel
carrier
lowering
bolt
and
mechanism.
Tyres
Check the tread depth of
al
I tyres, inspect al I
tyres for
signs
of
damage. Check the tyre pressures
when they are cold and
adjust
if
necessary.
Note
Include the spare tyre.
Test
Road
test
the
car
for
satisfactory
performance.
Seasonal Schedules
Every 12 months
Engine cooling system
Drain the coolant from radiator and engine
crankcase.
Fi
11
with
the correct
anti-freeze
mixture.
Ensure that the
flow
of coolant through the
heater tap feed hose wi
11
not be
restricted
by a
sharp radius
or
bend
in
the hose, by the hose
contacting
other adjacent pipework or by poor
alignment.
Clean any
debris
from the surfaces of the
refrigeration condenser and radiator matrices
by
reverse
flushing
with
a hose.
This
should
be
carried out
just
prior
to the autumn.
Body drain holes
Check that the body drain holes are unobstructed.
Air conditioning system
Check that the foam
filler
element(s)
fitted
to the
scuttle
intake
gri I
le
is
free from obstruction.
Refrigeration system
Check the refrigeration system for correct operation,
rectify
if necessary. Any work must
be
carried out
by
an
experienced engineer.
Every 2 years
In addition
to
12 monthly seasonal schedule,
carry out the fol
lowing
operation.
Engine cooling system
When
the coolant has been drained, thoroughly
reverse flush the
coolant
passages
with
a
con-
tinuous
flow
of
water.
Fit
new hoses where
necessary.
E22
•
10
Service Recommendations
For convenience these services
may
be
carried out
at the brake
pad
renewal nearest to the
specified
mileage.
Every 80 000 kilometres (48 000 miles)
At
this
mileage under normal motoring
conditions
it
is
recommended that the
following
servicing
is
carried out.
Automatic height control and braking systems
Examine the sub-frame to brake
caliper
hoses for
chafing or surface cracking; renew
if
necessary.
Fit
new front and rear accumulator to frame hoses.
Every 160 000 kilometres (96 000 miles)
At
this
mileage under normal motoring condi
lions
it
is
recommended that the
following
service
is
carried out.
Automatic height control and braking systems
Fit
all
new
flexible
hoses to the braking systems
and automatic
height
control system.
Fit
new
seals
to the
disc
brake
calipers
and the
deceleration conscious pressure I
imiting
valve.
Fuel
system
Fit
a new convoluted rubber hose between the fuel
fi
Iler
head and fuel tank assembly.
Examine al I
flexible
fuel pipes and renew any
which show signs
of
deterioration.
To Next Page
Loading...
