Check that the bal I and trunnion
joint
rubber
cover
is
secure and
in
good
condition.
Also
check
that
the
four
bolts
securing the
propeller
shaft to
the gearbox are
tight.
8. Rear
axle:
Check oi I
level;
top-up
if
necessary.
9.
Recirculatory heater
filter:
Clean recirculatory
heater
filter.
10. Shock dampers: Check
front
and rear shock
dampers for oi I leakage; top-up
if
necessary.
11. · Sparking plugs:
Fit
new sparking plugs ensuring
the
gaps are
set
correctly.
12. S1eering mechanism:
Lubricate
the thirteen
grease
nipples
on the
steering
mechanism.
Every 40 000 kilometres ( 24 000 miles)
In
addition
to the
10
000
kilometres
(6 000
miles)
and
the
20
000
kilometres
(12 000
miles)
service
schedules carry
out
the
following.
In the case
of
the Gearbox, Rear
axle,
Propeller
shaft
and the Power
assisted
steering
pump the
servicing
necessary
is
Ii
sted in
this
schedule therefore,
the
previous schedules should
not be consulted
for
these
items.
1.
Dynamo: Inspect the commutator and brushes
for wear,
also
check
the
brushes
for
freedom
of
movement
in
their
holders.
.
2. Engine breather system (Cars
fitted
with
enclosed crankcase breather system): Remove and
clean the gauze flame traps
in
the crankcase
breather tube.
3. Fuel pumps:
On
fuel pumps
fitted
with
an
additional condenser renew the
contact
points.
4.
Fuel tank: Release the drain
plug
and
allow
any accumulated
water
to
drain
away.
5. Gearbox: Drain the gearbox and
fluid
coupling,
fill
with
recommended
fluid.
Clean the breather in the
top
of
the
dipstick.
6. Power
assisted
steering
pump: Renew the
filter
element
in
the
steering pump
reservoir.
7.
Propeller
shaft:
Lubricate
propeller
shaft
uni versa I
joints
and
sliding
joint.
Check
that
the bal I and trunnion
joint
rubber
cover
is
secure and
in
good
condition.
If
the
joint
shows
signs
of
leakage,
dismantle
the
joint,
inspect,
rectify
as necessary
and
then
refill
with
grease.
Also
check
that
the four
bolts
securing the
propeller
shaft
to
the gearbox are
tight.
8. Rear
axle:
Change
rear
axle
oil.
9. Steering transfer box: Check
oi
I
level;
top-up
if
necessary.
Recommended Seasonal Schedules
Every 12 months
1.
Air
conditioning
system: Check
that
the
foam
filter
element
in
the
scuttle
intake
grille
is
free
from
obstruction;
fit
a new element
if
necessary.
Che~k the
refrigeration
system
for
correct
operation;
rectify
as necessary. Any work on the
refrigeration
system must
only
be
carried
out by an experienced
refrigeration
engineer.
2. Engine
cooling
system:
Drain
off
the
old
coolant
and
fi
11
the system
with
fresh
anti-freeze/water
D2
- 2
mixture or
inhibited
solution.
Just
prior
to the Autumn,
clean
any debris from the surfaces
of
the
refrig-
eration condenser and radiator matrices by reverse
flushing
with a hose.
Every 2 years
1. Engine
cooling
system: Carry out the 12 months
service
procedure and
also
thoroughly reverse
flush
the
cooling
system. Examine
coolant
hoses and
fit
new
hoses as necessary.
Service Recommendations
The
fol
I owing operations may be
carried
out
at
the
brake
reline
nearest
to
the
distance
intervals
specified.
It
is
emphasised that these
service
recommen-
dations
are not normal
servicing
arrangements and
should
only
be carried out at the request of the
Owner.
1.
Every
96 000 kilometres (60 000
miles):
Renew
the
brake hoses, wheel
cylinder
seals
and brake
master
cylinder
seals.
If
necessary, renew the
dust
and
water
seals
whi 1st
carrying
out the above mentioned procedures.
Completely drain the brake
fluid
from
the
hydraulic
systems and clean the
reservoirs.
Fi
11
with
approved
fluid
and bleed the systems.
To Next Page
Loading...
