Rolls-Royce Silver Shadow II - Page 174

~
Service
Bulletin
Bulletin number
Circi..:lation 11st
Category
ALL DEALERS IN USA AND CANADA
FLOOR INSULATION PAD
APPLICABLE TO:
(R{~E
MOTORS
CarDMsion
TSD4171
All Rolls-Royce Silver Shadow and Corniche cars frorn the following
Car Serial Numbers.
Silver Shadow saloon - SRD 20378 to 22427
Long Wheelbase saloon - LRD 20592 to 22437
Corniche - CRD 20171 to 22385
- DRD 20176 to 22322
! For full details refer to rear of this Bulletin •
..J
~
0
j PROCEDUPE:
0
CI
©
1. Disconnect battery.
2. Remove the three carpet clips from floor (see Fig. 1).
3. Securely staple or stitch the Velcro to carpets {see Fig. 1).
4. Raise car on hydraulic ramp (hoist).
5. In order to enable the floor insulation pad to be fitted
correctly on cars prior to Car Serial Numbers SRD 22118 and
LRD 22073 the brake pipe connector block must be slightly
repositioned. Figure 2 gives details of the re-location of
this block. DO NOT DISCONNECT THE BRAKE PIPES since this
will result in the need to bleed the system.
6. Remove the exhaust clamp and modify as Figure 2.
7. Offer up to the floor the thick insulation pad, the thin
insulation pad and the alloy cover. Ensure that the insula-
tion pads are encapsulated in the cover and that the cover~
forward-flange abuts the crossmember. Figure 2 shows the
cover in position.
8. Drill and secure the cover with the screws provided. It
may be found necessary to slacken and move the grass
shield round whilst drilling the floor.
9. Fit the clamp previously removed.
10. Fit the carpets to the car and connect the battery.