Rollsizer Decapper - Component Identification; Drop Tube and Feed Hose; Case Pusher and Controls; Decapping Die and Pegs

Operating and Maintenance Manual
7 | P a g e D e c a p p e r O & M M a n u a l R e v D
Refer to photographs below identifying the main components of the
Decappers.
Drop tube showing the
feed hose correctly
positioned / fitted.
Trim the other end if
you need to shorten
the hose.
On / Off / Reverse switch.
The reverse is a momentary
switch to assist in removal of
jammed cases.
Always disconnect the
power supply before
removing cases. Use long
nose pliers to remove cases.
Mounting holes
to screw base
to reloading
bench. (4
places)
Variable Speed
control dial.
2 x Discharge tubes for
cases and spent primers.
You will need to cut the
tube to suit.
Self-
aligning
pegs
FW Arms
Decapping
Die
Case
pusher