SB
MS
FB
FIGURE A
REQUIRED
STEP A (Two adults are required to complete this step)
Take your crib and carefully place it on the floor with the footboard (FB) on top,
taking care not to scratch its finish.
Remove all four bigger Allen bolts and washers (4+10) used to fix the footboard
(FB).
Adjust the mattress support (MS) to its lowest position (see STEP 2 for details).
Now, you must completely tighten all 8 bolts (5+11+7, 6+11) involved in mattress
support fixing using a Phillips screwdriver (not supplied).
REMINDER
You have to completely tighten a total of 8 bolts, distributed as following:
- 4 smaller rounded head bolts (6+11) in the stabilizing bars (SB);
- 4 bigger rounded head bolts (5+11+7) in the mattress support (MS).
4+10
4+10
4+10
4+10
NOTE: THE STYLE OF YOUR
CRIB, HEADBOARD OR OF
YOUR MATTRESS SUPPORT
MAY VARY FROM WHAT IS
P I C T U R E D I N T H E
INSTRUCTION SHEET
WARNING!
COMPLETELY TIGHTEN!
WARNING: TO KEEP
YOUR BABY SECURE AND
SAFE, AND TO AVOID
POTENTIAL INJURY OR
D E AT H , I T ' S V E R Y
I M P O R T A N T T O
COMPLETELY TIGHTEN
ALL 8 BOLTS LISTED IN
STEP A.
To Next Page
Loading...
