Rommelsbacher EKS 1500

Questions and Answers

C
Connie AriasAug 8, 2025
Why is my Rommelsbacher Coffee Maker temperature pilot lamp blinking quickly?
- K
  Krista WestAug 8, 2025
  A quickly blinking temperature pilot lamp on your Rommelsbacher Coffee Maker may be due to several reasons. It could be that the water tank is empty, so refill it and then bleed the system by dispensing hot water. Another possibility is that the water tank isn't correctly inserted; ensure it's fully inserted on the gasket, then bleed the system. Air in the system can also cause this, so bleed the system by dispensing hot water. The filter cartridge may not be soaked enough; soak it in water for at least 15 minutes before inserting. A blocked water filter could also be the cause; remove it and try dispensing water without it to see if the filter needs replacing. Finally, check that the rotary knob is in the correct position by turning it fully to the right or left.
C
Craig KeyAug 14, 2025
What to do if crema is not perfect in Rommelsbacher Coffee Maker?
- C
  Christina FowlerAug 14, 2025
  If the crema isn't perfect in your Rommelsbacher Coffee Maker, here's what you can check: * If there's not enough crema, the powder might be too coarse, not compressed enough, or the beans are too old. Also, the cup or machine might be dirty. * If the crema is too dark, the beans might be too old, or the powder is too coarse or not compressed enough. * If the crema is too light, the beans might be too old, or the powder is too coarse or not compressed enough. * If the crema isn't firm, the cup might be too cold or hot, or the water pressure might be too low.
R
rbarnettAug 18, 2025
Why does my Rommelsbacher Coffee Maker pump generate loud noise?
- O
  Olivia MartinezAug 18, 2025
  The loud pump noise in your Rommelsbacher Coffee Maker is because the water tank is empty during hot water or steam supply. Refill the water tank and then bleed the system by dispensing hot water.
K
Kristen GarciaAug 29, 2025
What to do if espresso flows irregularly from Rommelsbacher Coffee Maker?
- D
  Darryl WashingtonAug 29, 2025
  If the espresso flows irregularly or not at all from your Rommelsbacher Coffee Maker, it could be due to a blocked filter insert (clean it thoroughly), a blocked portafilter (clean it thoroughly), a blocked water filter (remove it and try dispensing water without it; replace if needed), or a blocked sieve in the tank (below the water filter, remove the water filter to clean the sieve). Also, ensure the appliance is on a horizontal surface, the powder isn't pressed too firmly or irregularly (correct compacting pressure is about 15 kg), there's no air in the system (bleed the system by dispensing hot water), and the appliance isn't calcified (decalcify according to instructions).
M
mariohuffmanSep 2, 2025
How to improve milk froth in Rommelsbacher Coffee Maker?
- M
  Mary RussellSep 3, 2025
  To improve the milk froth in your Rommelsbacher Coffee Maker, make sure you're using refrigerated milk. Also, use a suitable stainless steel jug. Finally, ensure the nozzle holes are not blocked and clean the nozzle thoroughly if needed.
E
Erin HardingNov 22, 2025
Why is the taste not okay with my Rommelsbacher Coffee Maker?
- R
  rstephensNov 23, 2025
  If the taste isn't right with your Rommelsbacher Coffee Maker, here are some things to consider: * **Bitter taste:** This could be because the beans are ground too fine, compressed too much, percolation is too long, too much powder is used, or there's too much pressure. * **Sour taste:** This might be due to unsuitable or too soft water, a too low brewing temperature, beans ground too coarsely, too light roasting, percolation being too short, or using the wrong coffee type (coffee roasting instead of espresso roasting). * **Off-flavour:** This could be caused by bad bean quality, beans stored for too long, chlorinated water, or using the wrong espresso type. * **Not enough flavour:** This may be because not enough powder is used, the coffee is too old, the powder is too coarse, th...