Step 1: With one person on each side of the bed about in the middle, carefully lift the bed tray and set the Bearing posts into the saddle on each side of the bed.
Make sure the bearing post gap is equal on each side. The key thing here is to take your time and get lined up right so you can limit the possibility of damaging
the wood Bed Tray Face or the interior finish of the Bed Case.
Step 2: Once both bearing posts are in the saddles, install the K158 bearing capture using the K138 screws.
Step 3: Prop up the foot end of the bed with some pillows or something and install the handles.
Step 1: Two people carefully lift
the bed tray so that the bearing posts
rest in the saddles on both sides.
To Next Page
Loading...