PREPARATION FOR ASSEMBLY:
Please locate and confirm that you have the following 4 boxes to complete your Queen Size Murphy Bed.
PLEASE NOTE: The boxes are numbered “BOX 1” through “BOX 4”, please open the boxes as they are called for in this Set-Up Guide,
beginning with BOX 1.
TOOLS & THINGS YOU NEED TO SUPPLY:
• A power drill gun with a #2 Phillips-head drive with a short extension.
• An Electronic Stud Finder.
• A step ladder that can safely hold your feet 30” off the floor.
• A pencil.
• A Queen-size mattress that is maximum 10” thick, and weighs maximum 70 lbs.
OTHER NOTES:
Please be aware that hardware parts will appear in each box as the Assembly Project progresses.
If and when parts are left over after completing a step, please lay them aside for use in a later step!
Please sift carefully through packing materials to make sure hardware packs don’t go out in the trash.
HAVE FUN! – and call us if you need assistance at 714-455-7446.
HELPFUL HINT:
Throughout the assembly of
your Murphy Bed, you will find it
helpful to refer frequently to
pages 25-28, where the contents
of each bubble pack and
hardware box are illustrated for
easy reference.
The bubble pack and hardware
box contents for the desk bed
can be found on page 31.
To Next Page
Loading...