ROOMS TO GO CREEKSIDE 2.0 - User Manual

WARNING DANGER
Failure to follow these warnings and assembly instructions could result in serious
injury or death. To help prevent serious or fatal injuries from entrapment or falls:
-
Read all instructions before assembling bunk bed and keep these instructions for future reference.
-
Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints, missing
parts, or sharp edges. DO NOT Use bunk bed if any parts are missing or broken.
-
DO NOT Use substitute parts. Contact your local Rooms To Go or visit www.ROOMSTOGO.COM
for replacement parts and instructional literature if needed.
-
Follow the information on the warnings appearing on the upper bunk end structure and on the carton,
DO NOT REMOVE WARNING LABEL FROM BED.
-
Always use the recommended size mattress or mattress supports, or both to help prevent the likelihood
of entrapment or falls.
-
Ensure thickness of mattress and foundation combine does not exceed
10 inches (255mm
) and
mattress surface is at least
5 inches (127mm)
below upper edge of guardrails.
-
Do not allow children under 6 years of age to use the upper bunk.
-
Periodically check and ensure that the guardrail, ladder, and other components are in their proper
position, free from damage, and that all connectors are tight.
-
Do not allow horseplay on or under the bed and prohibit jumping on the bed.
-
Limit top bunk use to one person.
-
Always use the ladder for entering and leaving the upper bunk.
-
Use of night light may provide added safety precaution for a child using the upper bunk.
-
Always use guardrails on both long sides of the upper bunk. If the bunk bed will be placed next to
the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and wall.
-
The use of water or sleep flotation mattress is prohibited.
-
This bunk bed meets all the requirements of ASTM 1427-19.
STRANGULATION HAZARD:
Never attach or hang items to any part of the bunk bed that are not designed for
use with the bed; for example, but not limited to, hooks, belts, and jump ropes.
CREEKSIDE 2.0 COLLECTION
THANK YOU FOR YOUR PURCHASE
11/7/2022
Page 1 of 97

Summary

Safety Warnings and Hazards

General Warning

Failure to follow warnings and assembly instructions could result in serious injury or death. To help prevent injuries from entrapment or falls:

Strangulation Hazard

Never attach or hang items to any part of the bunk bed that are not designed for use with the bed; for example, but not limited to, hooks, belts, and jump ropes.

Parts List and Identification

Bunkie Board Requirement

The bed slats included with this bed will not support a mattress alone; this bed requires Bunkie boards (sold separately).

Assembly Guidance: Two-Person Tightening

Two people are needed to assemble. Do not tighten completely until all pieces are connected together.

Assembly Instructions

Allen Wrench Usage Tips

Use the long end of the allen wrench to fasten bolts loosely and quickly, and the short end for final tightening.

Step-by-Step Assembly Guide

Instructions covering bottom side rails, slats installation, top side rails, and guardrails assembly.

Bunkie Board Installation

Correct Mattress and Bunkie Board Dimensions

Specifies correct mattress and Bunkie board dimensions for twin and full sizes.

ROOMS TO GO CREEKSIDE 2.0 Specifications