13
• If the sensor does not blink green, push the round test button on the front of the sensor for 2
seconds and then release. The sensor will start blinking green indicating that it is ready to connect
to the SmartBase.
• You will hear audio confirmation from your SmartBase (“Entry sensor connected”) and receive a
notification that your sensor is connected. The Entry sensor will also appear in your app.
• Repeat connection process with each Entry Sensor.
Placement
• Choose the locations where you would like to mount your Entry Sensors. We suggest prioritizing
the primary doors in your home. This could be your front door, back door or even sliding glass
doors. Additional entry sensors can also be located on ground level windows.
• Position the larger sensor on the fixed door/window frame with the rounded end on top. The
smaller magnet sensor should be located near the bottom of the larger sensor and placed on the
moving window/door. When the door or window is opened, the separation of the two sensors
trigger an alarm event. When closed, the sensors should be less than 5/8” (15mm) apart. Each
sensor pair is also marked with two parallel “alignment marks” to assist in positioning. These
sensor marks should be mounted opposite to each other to ensure alarm activation when the
entry door/window is opened.
To Next Page
Loading...