14
• NOTE - For homes that have large or higher profile frames
around windows and doors, it may be easier to position the
larger sensor on the moving door/window (vs frame) and the
smaller magnet sensor on the frame. Position the magnet
sensor on the frame angled towards the larger sensor alignment
marks. We’ve also included optional thicker foam tape pieces to
be placed underneath the larger sensor to position the sensor
further away from the door and closer to the magnet sensor
alignment marks (see photos).
• Before you mount the Entry Sensors with the adhesive tape, test
the alignment between each piece. The larger Sensor LED will
blink red and you will hear a chime tone from the SmartBase
when the door or window is “opened” and the pair is positioned
correctly.
• To mount, peel the adhesive tape from the small magnet piece and the larger sensor. Adhere the
small magnet piece to the door or window and the larger sensor to the doorframe or window
frame. Make sure that the magnet piece is aligned with the bottom of the sensor. Hold for 15
seconds to ensure that the pieces are firmly in place.
To Next Page
Loading...