18
Connecting to Wi-Fi
Your Roost Security360 system is designed with cellular and Wi-Fi. The cellular will connect
automatically during initial set up. However, by adding Wi-Fi connectivity, your system features will be
significantly enhanced, and you will have a more robust wireless backup capability. We highly
recommend connecting your Security360 to Wi-Fi as an essential part of the setup process.
Key Features Enabled with Wi-Fi
• Remotely arm and disarm your system via the app
• Ability to perform full system test with all sensors
• Failsafe wireless connectivity – If Wi-Fi goes down, system switches over to cellular backup
• Setting PIN codes via app
• Activating professional monitoring via app
• Changing entry and exit delay periods via app
• Enabling or disabling entry sensor chime tone via app
How to Connect to Wi-Fi
• Follow the yellow “prompt” in the app that will pop up when it is time to connect to Wi-Fi.
• Click on the SmartBase icon in the app. Then select “Connect to Wi-Fi” and follow the steps in
the app.
• Make sure that you have your Wi-Fi password handy when going through these steps.
• Follow the step-by-step app instructions
To Next Page
Loading...