22
RootsScrub E4550 ES
MACHINE OPERATION
The Ext scrubbing procedure is used when external accessories
are used.
Ext Cleaning Mode:
= Set the switch position to EXT mode.
= Connect the required external accessory at the front port.
= Remove the suction hose from the brush head and connect it
to the external accessory.
= Switch On the machine to use the connected accessory.
Ext mode
Water port for
external accessory
In Ext. mode the water will be sprayed from the nozzles located
on the accessory when the trigger is pressed.
The suction will switch off when the dirty water tank reaches its
maximum capacity or if the fresh water level gets empty.
Note:
Ú In this mode water will be sprayed inside the suction hose
assembly.
Ú Also check the flow of water from the nozzle at the first start of
the day.
External accessory attached to the machine.
è To connect the external accessory follow the
below steps:
Disconnect the suction hose assembly from the
brush head (a).
Connect the long suction hose to the disconnected hose
assembly (b).
Connect the water supply hose at the port on the brush head as
shown in the picture (c).
(a)
(b)
(c)
To Next Page
Loading...