ROOTS RootsScrub E4550 ES - MAINTENANCE; Draining of Dirty Water Tank; Cleaning of Fresh and Dirty Water Tanks

27
RootsScrub E4550 ES
Draining of Dirty Water Tank
= Move the machine to the designated waste disposal area.
= Lower the dirty water tank drain hose to the floor.
= Open the cap of the drain hose.
= Upon end of draining close the cap and secure the hose in its
storage position.
WARNING
DO NOT DRAIN THE DIRTY WATER INTO THE
ENVIRONMENT. RISK OF CONTAMINATING
THE ENVIRONMENT.
This section describes on maintenance of the machine under the
following sections:
è Draining of dirty water tank
è Cleaning of the fresh and dirty water tanks
è Cleaning the brush, nozzles, in-feed filter
è Cleaning the machine
è Electrical maintenance
è Post-scrubbing checkpoints
è Storing the machine
MAINTENANCE
Cleaning of Fresh and Dirty Water Tanks
= Move the machine to the designated cleaning area.
= Lower the dirty water tank drain hose to the floor.
= Lower the fresh water tank drain hose to the floor.
= Open the cap of the drain hoses.
= Fresh Water Tank - Open the lid of the filter assembly and
remove the filter to gain access to the tank. Hose down the
inside of the tank with clean water at normal pressure.
= Dirty Water Tank - Open the top lid of the dirty water tank and
check for any solid debris around the walls and the float, if
found remove them. Hose down the inside of the tank with
clean water at normal pressure. If necessary use a mild
detergent.
WARNING
DO NOT DRAIN THE DIRTY WATER INTO THE ENVIRONMENT.
RISK OF CONTAMINATING THE ENVIRONMENT.
CAUTION
Ensure that the tanks are completely cleaned and
no residual waste is accumulated.
Also ensure that the lids of the filter and tank are
closed after cleaning is complete.
Fresh water tank cleaning
Dirty water tank cleaning
WARNING
DO NOT USE A HIGH PRESSURE JET CLEANER.
DO NOT USE A STEAM CLEANER.
DO NOT DIRECT WATER INTO THE ELECTRICAL PARTS.
MAINTENANCE