ROOTS RootsScrub E4550 ES - Cleaning the Brushes; Cleaning the Nozzles; Cleaning the Pump In-feed Filter

28
RootsScrub E4550 ES
Cleaning the Brushes
Cleaning the Float Filter
= Move the machine to the designated maintenance area.
= Remove the debris tray from the brush head.
= Open the idler side cover to gain access to the brushes.
= Pull out the brushes from the brush head.
= Clean the brushes and the debris tray under running water
and with detergent.
= Remove the nozzle adapter (a) by twisting it once anti-
clockwise by hand.
= Remove the nozzle (b) and filter (c) from the union.
= Clean the nozzle and filter under fresh running water to
remove any dirt or debris.
= Place the nozzle and filter back and secure it by placing the
adapter back.
= Remove the mesh filter (a) by unscrewing the bottom cover
(b).
= Clean the mesh filter under fresh running water to remove any
dirt or debris.
= Place the cleaned mesh filter back and secure it with the
bottom cover.
CAUTION
DO NOT clean the brushes with a high pressure washer.
DO NOT clean the brushes into the environment.
Cleaning the Nozzles
Cleaning the Pump In-feed Filter
Note: Do not use harsh acidic solutions to clean the nozzle and
filter.
Note: Do not use harsh acidic solutions to clean the nozzle and
filter.
a
b
c
a
b
Remove the float filter by
unscrewing the wing nut,
and clean it under running
water using a brush.
U s e m i l d d e t e r g e n t i f
required.
MAINTENANCE