10
USING YOUR WASHER
UNDERSTANDING WHAT HAPPENS IN EACH CYCLE
When the Cycle Control knob is set to a number and
pulled out, the washer fills (to the selected water
level) before agitation and timing start. The washer
begins agitating immediately after filling; agitation
occurs with the washer lid up or down.
After agitation starts, the Cycle Control knob turns
clockwise until it points to an Off area and the
cycle ends.
NOTE: The washer pauses briefly throughout
each cycle. These pauses are normal for washer
operation.
Sequence of cycles
Fill
▼
Rinse
▼
Drain-No agitation
▼
Spin-Spray rinse
▼
Spin
▼
Off
Fill
▼
Wash selected time
▼
Drain*
No agitation
▼
Spin
▼
WASH
RINSE
*The Permanent Press cycle partially drains, fills, agitates
briefly, and drains.
To Next Page
Loading...
