Solving common ice maker problems
PROBLEM
POSSIBLE CAUSE/SOLUTION
Ice crescents attached
l
This is normal. They break apart easily. Shake bin occasion-
at corners
ally to keep cubes separated.
Ice maker will not
l
ON/OFF lever is in the OFF (up) position. Lower lever to the
operate or Ice is not
ON (down) position.
made fast
enough
l
Freezer is not cold enough. Adjust temperature controls and
wait 24 hours. (See “Changing the control settings” on
page a.1
Off-taste
or odor In ke
l
New plumbing connections can cause discolored or off-
flavored ice. Discard the first few batches of ice.
l
Cubes are stored too long. Throw them away and make a
new supply.
l
Foods in freezer are not wrapped properly. See “Food
Storage Guide” on pages 19 and 20.
l
Freezer and ice bin need to be cleaned. See pages 15
and 16.
Changing the light bulb
Electrkal Shock Hazard
Before removing a light bulb, either
1 unplug the refrigerator or disconnect
the electricity leading to the refrigerator
at the main power supply.
Failure to do so could resuft in electri-
cal shock or personal injury.
To change the refrigerator light:
1.
Disconnect refrigerator from power supply.
2. Reach behind Control Panel to bulb.
3.
Replace bulb with a 40-watt
appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: All appliance bulbs will not fit in your
refrigerator. Be sure to replace a bulb with
one of the same size and shape.
11
To Next Page
Loading...
