SATA105G/ATA 133 RAID Controller Card RC215 User Manual
10
For Windows® 2000
For A New Installation
A new installation requires a floppy disk for the driver installation. To make
this floppy disk, copy the contents of the “RC-212\VRAIDDrv\drvdisk” folder,
found on the driver CD, onto a blank floppy disk then follow the directions
below.
Setup the RAID Array prior to Windows installation.
Follow Windows® 2000 installation procedure.
Restart the computer when prompted by the installation.
At the Windows® 2000 Setup screen, press F6 to install the RAID driver.
When prompted, press S to specify the location of the driver.
Insert the floppy disk, then press Enter.
Select VIA V-RAID Controller Series (Windows 2K), then press Enter.
Press Enter again to finish driver installation, then follow the on-screen
instructions to complete the Windows installation.
For An Existing Installation
Setup the RAID Array prior to driver installation and boot up to Windows.
At the Found New Hardware Wizard window pop-up, please click Cancel
button to cancel the driver installation for the device at this moment. The
driver for this device will be installed in the next step.
Please insert the CD driver bound with PCI SATA+PATA RAID card into your
CD-ROM Drive.
At the Windows desktop, click Start, then Run.
Type D:\RC-212\SETUP.EXE, click OK. (Change D:\ to match your CD-ROM
drive letter)
Follow the on-screen instructions to complete the installation.
To Next Page
Loading...
Need help?
General