3.
Switching to manual operation (radio-controlled mode OFF)
By pressing the M-Set button for ca. 3 seconds the clock
can be switched to manual mode of operation. Press the M-
Set button again to manually set the time. After ca. 5 se-
conds the minute hand will move clockwise. The hand’s
movement will stop when the M-Set button is released. After
approx. 6 seconds the clock will start to operate in manual
mode.
Note: By removing and reinserting the battery, the clock will switch back to
the radio-controlled mode of operation. The manual setting will have to be
reset, if required.
4. Technical Data
Your new radio-controlled Wall Clock responds to the DCF-77
signal and is synchronized twelve times daily. The signal is
elayed from a central transmitter at Frankfurt/Main, Germany.
ROE_Bedien_Wanduhr_funkg.indd 16 19.10.2011 15:04:51
To Next Page
Loading...